Kohler Command CV17-750 Service Manual page 66

Section 5
Fuel System and Governor
Choke Lever Detail
Choke Cable
Control
Bracket
Blower Housing
Washer
Spring
Figure 5-68. Governor Used with Commercial Mower Air Cleaner (CV17-745).
Commercial Mower Governor
Arrangement
The Commercial Mower governor arrangement shown
in Figure 5-68 is used primarily on wide area walk
behind mower applications. The initial adjustment
and sensitivity adjustment is the same as for the
standard governor. The governor and controls for the
CV750 engine is shown in Figure 5-69. Should the
governor spring be disconnected from the throttle
lever and governor lever, reconnect it as follows:
5.32
Fastener
Choke Lever
(See Detail at Left)
Screw and Nut
Control Lever
Clip
Lever
Spring
Washer
Locker Nut
Fastener
Throttle
Lock Nut
Cable
Clamp
Clamp
Bushing
Fuel Line
Spring
Linkage
Bushing
Throttle Shaft
Bracket
Deflector
(If So Equipped)
Spacer
(Place Between Valley
Throttle Lever
Baffle and Throttle
Shaft Bracket)
1. Hook the long end of the spring through the hole
in the lever from the left side.
2. Rotate the spring 180° until hooked as shown in
Figure 5-69.
3. Hook the short end of the spring into the
appropriate hole in the governor lever. Refer to
the appropriate chart in Section 11 - "Reassembly"
of this manual for the correct hole to use for the
speed involved.
Choke Lever
Screw
Washer Spring
Washer
Lock
Spacer
Nut
Linkage
Fuel
Pump
Bushing