Kohler Command CV17-750 Service Manual page 57

Figure 5-43. Fuel Bowl Removed From Carburetor.
3. Remove the float pin screw and lift out the old
float, pin and inlet needle. See Figure 5-44.
Discard all of the parts. The seat for the inlet
needle is not serviceable, and should not be
removed.
Figure 5-44. Removing Float and Inlet Needle.
4. Clean the carburetor bowl and inlet seat areas as
required, before installing the new parts.
5. Attach the inlet needle to the plastic tang of the
float with the wire clip. The formed 90° lip
should point up, with the needle valve hanging
down. See Figure 5-45.
Fuel Bowl
Bowl Drain Screw
Fuel System and Governor
Figure 5-45. Float and Inlet Needle Details.
6. Install the float and inlet needle down into the
seat and carburetor body. Install the new pivot
pin through the float hinge and secure with the
new retaining screw. See Figure 5-46.
Figure 5-46. Installing Float Assembly.
7. Hold the carburetor body so the float assembly
hangs vertically and rests lightly against the fuel
inlet needle. The inlet needle should be fully
seated but the center pin of the needle (on
retainer clip end) should not be depressed. Check
the float height adjustment.
NOTE: The inlet needle center pin is spring loaded.
Make sure the float rests against the fuel inlet
needle without depressing the center pin.
8. The correct float height setting is 17 mm
(0.669 in.) ± 1.5 mm (0.059 in.), measured from
the float bottom to the body of the carburetor. See
Figure 5-47. Replace the float if the height is
different than the specified setting. Do not
attempt to adjust by bending float tab.
Section 5
5
5.23