ComMarker Omni User Manual page 14

14
7.You can see the following window, UV/YAG
"next"
9.Click "finish" and it will in the device list and it will in the device list
11. Go to "Basic Settings" from "Device setting
click "Load COR file", Select "omni 1
"JCZ15.cor", Click "OK"
UV/YAG and click 8. Change the name if necessary, and input the right X
Device setting" button,
omni 1", Choose file
8. Change the name if necessary, and input the right X
and Y Axis Length according to the lens. Click "next" and Y Axis Length according to the lens. Click
10. The status will change into "Ready" when the 10. The status will change into
machine is on and connected via USB machine is on and connected via USB
12. Change the setting of Freq "Min 1", "Max 40". 12. Change the setting of Freq
Switch on "Galvo 2". Set the Laser Type UV, a Set the Laser Type UV, and it is
ready to control the machine with Lightburn. ready to control the machine with Lightburn