ComMarker Omni User Manual page 11

11
4. Adjust the focus
Press up or down button to lift or lower the laser head until the 2 red light point overlap, which is the best Press up or down button to lift or lower the laser head until the 2 red light point overlap, which is the best Press up or down button to lift or lower the laser head until the 2 red light point overlap, which is the best
focal point.
The measuring focal length of this machine is ___________ mm (70x70) and _________ mm (150x150), The measuring focal length of this machine is ___________
and the measuring distance is the length from the middle line of the Galvo to the surface of the engraving and the measuring distance is the length from the middle line of the Galvo to the surface of the engraving and the measuring distance is the length from the middle line of the Galvo to the surface of the engraving
material. This parameter is measured manually, and each device has different focal lengths due to changes material. This parameter is measured manually, and e
in laser sources and field lenses.
Note:
*The overlapping point should be on the marking material other than the surface of the machine. The overlapping point should be on the marking material other than the surface of the machine. The overlapping point should be on the marking material other than the surface of the machine.
*Red light correction before shipping. At the
strongest light. However, due to transportation reasons, the focus point of the red lights you received may shift, strongest light. However, due to transportation reasons, the focus point of the red lights you received may shift, strongest light. However, due to transportation reasons, the focus point of the red lights you received may shift,
and the focus point would not be the best focal length. and the focus point would not be the best focal length.
Please follow the steps for debugging.
1.Place the stainless steel test plate on the machine table 1.Place the stainless steel test plate on the machine table
3.Turn on the machine, connect the computer with the 4.Import the "TEXT" for testing , select the default 3.Turn on the machine, connect the computer with the
machine
ach device has different focal lengths due to changes
. At the position where the 2 red light spots are focused, the laser emits the position where the 2 red light spots are focused, the laser emits the
2.lift up or down the laser head to the best focus point 2.lift up or down the laser head to the best focus point
according to the number in handwriting above according to the number in handwriting above
parameters, and tick the "continuous part
70x70) and _________ mm (150x150),
for testing , select the default
continuous part" button.