ComMarker Omni User Manual page 12

12
5.Press "red light" to ensure it'll mark on the test
material. Click "mark", and the laser would be
continuously marking
7.At this time, loosen the screws for the two beams of 8.Manually adjust the relative position 7.At this time, loosen the screws for the two beams of
the auxiliary red light
5. Marking test
Place the test engraving material on the machine. Click "Red Light (F1)", the area shown by the red light is Place the test engraving material on the
the marking area. Choose the parameters according to the Choose the parameters according to the following picture. Click "Mark (F2)" to start
marking.
Note: "Speed", "Frequency" and "Q Pulse Width
ll mark on the test
, and the laser would be
Q Pulse Width" are key parameters for marking result.
6. Meanwhile, lift or lower the laser head and observe
the obvious change of intensity of the laser beam. Stop the obvious change of intensity of the laser beam. Stop
when the it works with the strongest laser when the it works with the strongest laser
8.Manually adjust the relative position of the red light
dots to make them overlap.And tighten the screws dots to make them overlap.And tighten the screws
. Click "Red Light (F1)", the area shown by the red light is
are key parameters for marking result.
lower the laser head and observe
. Click "Mark (F2)" to start