Advertisement
Quick Links
2-SIDED AND 3-SIDED ALCOVE DESIGNS
Important
0324
INSTRUCTION MANUAL
Acrylic
1. When you receive your Acrylic Tray and Liner, check that they
are the correct type, size and free of freight damage or any
other defect.
2. Advise Newline on 0508 639 5463 if any damage has occurred
3. It is essential that items 1 and 2 are followed as installation of
incorrect or damaged product will void a warranty cover.
Advertisement
Related Manuals for NewLine Acrylic Low Profile Tray
Summary of Contents for NewLine Acrylic Low Profile Tray
- Page 1 2. Advise Newline on 0508 639 5463 if any damage has occurred 3. It is essential that items 1 and 2 are followed as installation of Important incorrect or damaged product will void a warranty cover.
-
Page 2: Warranty
• Hot water temperature must be regulated to 55 degrees to comply with the warranty. • Full warranty information can be obtained at www.newline.nz/warranty-information/ HEALTH AND SAFETY • Keep room well ventilated to dissipate glue vapours. TOOLS REQUIRED... -
Page 3: Preparation Checklist
PROCESS Preparation Checklist The builder is responsible for these steps to enable a successful shower installation. The Floor: Wall Framing crosswise. The Wall Board Plumbing: IMPORTANT INFORMATION WALLBOARD LINING OF SHOWER WALLS Two-Sided: provided all frame detailing is complete. Place the tray upstand and trim this lower section of wallboard out. - Page 4 INSTALLATION 2-Sided Tray Layout NEXT PAGE 3-SIDED ALCOVE: GIB AQUALINE ® GIB AQUALINE ® Diagram A or equivalent or equivalent Liner Glue Acrylic Wall Liner Framing Support Batten Aquacheck Seal Bottom Plate Anti Capillary Gap Tray...
- Page 5 Gib Lining to Liner Back Wall Frame Lining O/A width +/-1mm 1000 1200 1180 1175 Diagram B Gib Aqualine Acrylic Wall Liner Support Batten AquaCheck Seal Bottom Plate Newline Tray Gib Lining to Lining Frame to Frame correct liner installation.
- Page 6 INSTALLATION Have you done the Page 3 Checklist? STEP 1 • protect the surface during installation and stop any item going down the drain. • Diagram C Tray upstand Aquacheck seal waste connection is End Block STEP 2 • Glue the tray down with Maxbond at the rings underneath. Apply a small seal of silicone underneath the outside edge and place and hold the tray in position against the wall framing and with a little downward weight.
- Page 7 INSTALLATION Bonding + Sealing Lines STEP 3: Wall Liner Installation Marking Out • plane • • • If Wetwall Caddy is installed: Full circle of silicone around plumbing cutouts. Gib Centre Seal top edge of liner with a paint Caddy Face Plate Liner hole compatible sealant.
- Page 8 CONTACT 54 Unutoto Place, Tauriko, Tauranga, 3171 Freephone: 0508 639 5463 Phone: 09 444 2053 Email: info@newline.co.nz newline.nz...
Need help?
Do you have a question about the Acrylic Low Profile Tray and is the answer not in the manual?
Questions and answers