Download
Share
Print this page
NewLine Ravello Instruction Manual
  1. Manuals
  2. Brands
  3. NewLine Manuals
  4. Bathroom Fixtures
  5. Ravello
  6. Instruction manual

NewLine Ravello Instruction Manual

2-sided and 3-sided alcove
Hide thumbs Also See for Ravello:

Advertisement

Quick Links

Download this manual
2-SIDED & 3-SIDED ALCOVE
Important!
1. When you receive your Ravello shower check contents for any freight damage or defect.
2. Advise Newline on 0508 639 5463 if any damage has occurred within 8 hours of receiving
the goods so this can be rectified.
3. Do not proceed with installation until resolved as there cannot be a valid claim later.
JULY 2020
Ravello 2-Sided and 3-Sided Alcove
INSTRUCTION MANUAL
CODES: G9663

Advertisement

loading
Need help?

Need help?

Do you have a question about the Ravello and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for NewLine Ravello

Summary of Contents for NewLine Ravello

  • Page 1 Important! 1. When you receive your Ravello shower check contents for any freight damage or defect. 2. Advise Newline on 0508 639 5463 if any damage has occurred within 8 hours of receiving the goods so this can be rectified.

  • Page 2: Warranty

    IMPORTANT INFORMATION WARRANTY • Faulty goods are covered under warranty. Visit www.newline.nz for warranty information. • Breakages incurred during installation are not covered under warranty. • Installations must conform to the instructions to be covered by the warranty. HEALTH AND SAFETY Toughened Glass: •...

  • Page 3: Preparation Checklist

    Waterproofing “ProFinish Tile Trays”: This must comply with AS/NZS 4858:2004 and be undertaken by certified applicator and a Producer Statement provided. There is a list of proven systems on our website www.newline.co.nz Tiling: 1. A complete system must be used. i.e. Waterproofing - Tile Adhesive - Grouting - Silicone. This is for full accountability and performance requirements.

  • Page 4: Exploded View

    EXPLODED VIEW DIAGRAM & COMPONENT LIST 2-SIDED CHROME + BLACK EXPLODED VIEW COMPONENT LIST - CHROME + BLACK CODE PART CODE PART CODE PART CHROME BLACK CHROME BLACK CHROME BLACK Door Handle H5542 H5504 Top Door Rail H5634 H5641 Return Wall Plugs Door Stops H5658...
  • Page 5 EXPLODED VIEW DIAGRAM & COMPONENT LIST 3-SIDED CHROME + BLACK EXPLODED VIEW COMPONENT LIST - CHROME + BLACK CODE PART CODE PART CODE PART CHROME BLACK CHROME BLACK CHROME BLACK Door Handle H5542 H5504 Top Door Rail H5634 H5641 Wall Plugs Door Stops H5658 H5665...
  • Page 6 INSTALLATION ACRYLIC 2-SIDED LAYOUT STEP 1 ACRYLIC • Mark the two wall profiles 19mm back from the outside edge of the tray. • Use the minimum to maximum table to check this lay-out and adjust if required . • Predrill the wall profiles, align to wall markings and drill a 2mm lead hole in the liner. •...
  • Page 7 INSTALLATION TILE 2-SIDED LAYOUT STEP 1 TILE • Identify your installation measurement from the table below. Mark outside line of wall profiles. The base profiles being 2mm inside this (dotted lines). • Bond wall profiles as outlined in the “Penetration of Waterproofing” below. Component assembly follows from Step 2, Page 9.
  • Page 8 INSTALLATION 3-SIDED ALCOVE LAYOUT This Diagram covers Acrylic and Tile installations and guidance. • Acrylic Tray: Positioning the wall profile 20mm off edge of the tray. • Tile Tray Level Entry: Locate at transition centreline where the slope starts. • Tray with Hob: Position the boundary line 35mm back from outside of finished hob.
  • Page 9 INSTALLATION TILE & ACRYLIC STEP 2 The fixed glass requires the floor profile with knock-on seal attached. Find the three components as drawing 1. Fixed front glass 2. Knock-on seal 3. Floor profile Assembly Steps: • Place fixed glass onto suitable support with protection Fixed Front Glass layer as Diagram A.
  • Page 10 INSTALLATION TILE & ACRYLIC STEP 3 CORNER CLIPS Cut-out is only on return panel DOOR LINE DOOR LINE IMPORTANT! Be sure you select the right clip for your corner. Of the two options provided only one will work. Diagram C1 Diagram C2 Corner Clip CAUTION: Fit return glass and fixed front glass progressively into the wall profiles.
  • Page 11 INSTALLATION TILE & ACRYLIC STEP 5 Diagram E Diagram F • Note: Rubber insert in the guide must be removed • Assembly all parts to door. and turned to 8mm glass adjustment. Insert tightly • Fit door on top rail and into lower guide. back in place.
  • Page 12 25mm to wall 25mm STEP 7 Diagram J • Apply silicone seal to dotted line as indicated. • Leave for 24 Hrs to cure. 150MM 150MM 150MM 150MM CONTACT Freephone: 0508 639 5463 Phone: 09 444 2053 Email: info@newline.co.nz www.newline.co.nz...