Washing Sequence - Haier HWM66-0613TT User Manual

Ï ´ µ Ó Ë ³ Ð ò

Washing sequence

Wash timer
Wash selector
(To set to below 2 minute,
first set to 5 minute then
turn it back. it can increase
the service life of the timer).
3
6
9
12
45
15
EMBEBER EMBEBER
35
25
WASH TIMER
Wash
1.Water-filling selector
(1) Set the water-filling selector at the "WASH" side.
(Figure 1)
(2) Set the water level adjusting lever to needed line.
2. Fill the water and add the dissolved washing
powder to make the water level reach the preset
position. (Figure 2)
Run washing program for some time to stir and
dissolve the powder completely.
3.Put in the laundries. If the water quantity is
insufficient, please add water.
4.Select the current.
Select the strength of the current according to
the laundries. (Figure 3)
5.Select the washing time
Select the washing time according to the
laundries. (Figure 4)
Remarks:
1. 0~15 minutes is the normal washing.
2. 15~45 minute is active soaking. During active soaking, the pulsator
will run for 2 minutes in each 8 minutes. After the active soaking, it
will run normal washing for 15 minutes.
3. If you select soaking(i.e. turn the knob to position between 15~45
minutes), be sure to dissolve the washing powder in advance,
otherwise the washing powder may result in
damage to the laundries.
6.After washing, set the "WASH SELECTOR"
at "DRAIN". (Figure 5).
(Strong current,
standard current)
WASH SELECTOR
Water-filling entrance
WASH SELECTOR
9
Water-filling selector handle
Overfilling sign
Spin timer
(to set to below 1 minute,
first set to 2 minute then
turn it back. it can increase
the service life of the timer).
5
4
3
SPIN TIMER
WASH SPIN
3
6
9
12
45
35
25
WASH TIMER
WASH SELECTOR
1
2
Figure 1
Figure 2
Figure 3
15
Figure 4
Figure 5