Washing Sequence - Haier HWM65VA User Manual

Washing sequence

Wash timer
(To set to below 2 minute,
WATER INLET
first set to 5 minute then
turn it back. it can increase
the service life of the timer).
3
15
12 6
9
WASH TIMER
Wash
1. Fill the water and add the dissolved washing
powder to make the water level reach the preset
position. (Figure 1)
Run washing program for some time to stir and
dissolve the powder completely.
2.Put in the laundries. If the water quantity is
insufficient, please add water.
3.Select the current.
Select the strength of the current according to
the laundries. (Figure 2)
4.Select the washing time
Select the washing time according to the
laundries. (Figure 3)
5.After washing,Set the "WASH SELECTOR"
at "DRAIN". (Figure 4).
Wash selector Spin timer
(Strong current,
(to set to below 1 minute,
standard current)
first set to 2 minute then
turn it back. it can increase
the service life of the timer).
STRONG
5
1
STANDARD
DRAIN
2
4
3
SPIN TIMER
WASH SELECTOR
Figure 1
STRONG
STANDARD
DRAIN
Figure 2
WASH SELECTOR
3
15
12 6
Figure 3
9
WASH TIMER
STRONG
STANDARD
DRAIN
WASH SELECTOR Figure 4
8
How to change the direction of the drain hoses
Figure 1 indicates the ex factory installation
position of the drain hose.
Extend the drain hose from the side of wash tub.
Put soft items on the ground. Lean the machine
down gently with the front surface facing the
ground. Take off the drain hose from the cabinet.
Take the hose out of the fixing groove.
(See to Figure 2).
Embed the drain hose into the groove along the side
of the spin tub in the order of (1)~(3), heading for the
side of the wash tub. (See to Figure 3).
Embed the drain hose into the groove with
hands. Take care not to damage the drain
hose in fastening the fixing clamp.
Install the water inlet hose; Select the water level
Insert the water inlet hose into the water-filling
entrance on the control panel directly.(pull it
out to dismantle it)
Select water level according to the
quantity of the laundries.
Set the water level adjusting lever
to needed line.
Use the new water inlet hose provided
with the machine to connect to the
water faucet.Old hose sets should
not be reused.
Soft item
Figure 1
Soft item
Figure 2
Figure 3
Extend to the
Embed into the
spin tub side
groove in turn
Water inlet hose
Water inlet Water inlet
Water level
indicator
Maximum Max.
Med
Medium
Min
Minimum
5