Removing An Internal 3.5-Inch Hard Drive - HP Compaq 6000 Pro MT Maintenance And Service Manual
Business pc
Hide thumbs
Also See for Compaq 6000 Pro MT:
- Maintenance & service manual (125 pages) ,
- Troubleshooting manual (67 pages) ,
- Hardware reference manual (67 pages)
Table of Contents
Advertisement
Removing an Internal 3.5-inch Hard Drive
NOTE:
Before you remove the old hard drive, be sure to back up the data from the old hard drive so
that you can transfer the data to the new hard drive.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Disconnect the power cable (1) and data cable (2) from the back of the hard drive.
Figure 8-25
4.
Release the drive by pulling the release tab away from the drive (1) and sliding the drive out of the
bay (2).
Figure 8-26
5.
Remove the four guide screws (two on each side) from the old drive. You will need these screws
to install a new drive.
(Access Panel on page
Disconnecting the Hard Drive Cables
Removing a Hard Drive
(Preparation for Disassembly on page
77).
76).
Installing and Removing Drives
99
Advertisement
Table of Contents
