After Software Setup - Compaq Evo N200 Hardware Manual

If the icon does not display on the Desktop after initial setup
is complete, select Start > Run. On the command line, type:
C:\cpqapps\setup.exe preload
✎
To display descriptions and space requirements of preloaded
Compaq utilities without installing them, select the Setup
Compaq Software icon on the Desktop, then select Next. After
viewing the utility information, select Cancel, then select Exit
Setup.

After Software Setup

After the initial setup is complete, you may want to:
I
Calibrate the battery pack.
Although you can use a new battery pack that has been fully
charged to run the computer, the amount of charge in the
battery pack may not be reported accurately until the battery
pack has been calibrated. For calibration information and
instructions, refer on this CD to the Utilities guide, "Power
Management" section.
I
Set the power switch, suspend button, or display switch to
initiate Hibernation.
Hibernation is an energy-saving feature and safeguard that
saves all information in RAM (random access memory) to a
hibernation file on the hard drive, then shuts down the
computer. When you exit Hibernation, your work returns to
the screen where you left off. To replace a battery pack that is
the sole power source, you must either initiate Hibernation or
shut down the computer.
Although Hibernation can be initiated from the Microsoft
Windows 2000 Professional operating system Shut Down
menu, it may be more convenient in either the Windows 2000
Professional or the Microsoft Windows XP Professional
operating system to initiate it from a button or switch. For
Hardware Guide
Hardware and Software Setup
1–5