Hardware And Software Setup; Setting Up The Hardware - Compaq Evo N610c Series Getting Started

Hardware and Software Setup

Setting Up the Hardware

Ä
CAUTION: Setup must begin with connecting the notebook to AC power.
To ensure that the correct drivers load and to prevent file corruption or
damage to the components during initial setup:
I
Do not remove the battery pack until the notebook has been
connected to external AC power.
I
Run the notebook on external AC power, not on battery power,
throughout initial setup.
I
Do not set up the notebook while it is docked in an optional Port
Replicator.
1. Place the notebook on a flat surface near an electrical outlet,
then connect the notebook to external AC power.
Hardware Guide
1
1–1