Disposal Of The Collection Vessel - Metasys MULTI SYSTEM TYP 1 ECO Instructions For Use Manual

If the pump sieve (1) is dirty, pull it off, clean it over a collection receptacle and put it back on the suction
housing of the pump.
4 Wipe the probes in module 2 (2) with a paper towel. For easier cleaning of module 2, the air brake (3)
can also be removed.
When assembling, pay attention to the position markings (arrow on the air brake, notch on module 2)!
Place the cleaned and properly assembled module 2 on the new collection vessel.
Pay attention to the FRONT marking on the collection vessel!
5
Close the 4 yellow clip fasteners on module 2.
6
Clean the sealing rings on the left and right in the retaining element with a damp paper towel and
grease them with multi-silicone grease (or Vaseline).
7 Carefully push module 2 back into the holder and close the locking clip.
Switch on the main switch of the treatment unit.
8
Signal 1 on the internal display lights up (only on MST 1 ECO)
7.2.2.

Disposal of the collection vessel

The full collection vessel can be submitted to the company's own disposal organisation, METASYS logistics & collection GmbH.
When the complete device is disassembled at the end of its service life, it can be returned to the manufacturer for correct disposal (see 8.2. Recycling and disposal).
Cut open the disinfectant bag for final disinfection (enclosed with the new vessel) and pour the contents
1
into the full collection vessel.
Care and maintenance | EN
3
2
1
New Old
19