Pipe And Hose Connections - Metasys MULTI SYSTEM TYP 1 ECO Instructions For Use Manual

EN | Preparation for use
5.2.2.

Pipe and hose connections

1
1 Connection for rinsing basin drain hose
2 Connection for suction hose (for hose storage)
3 Connection for vacuum hose (to suction machine)
4 Connection for drain hose (clean water outlet)
Attention:
Unused connections must be sealed with blind plugs!
> The hose routes leading to the device must be kept as short as possible to prevent pre-sedimentation.
> Dirty dental hoses must be replaced during installation and disposed of by an approved company.
> The device must be connected to the sewage pipe via an odour trap.
> Water jet operated saliva ejectors are to be shut down due to high water consumption.
> For matching hose nozzles and adapters see 9.1.1. Accessories, service kits, collection vessels and spare parts.
12
Installation in the back-of-the-head position
If there is no rinsing basin at the treatment site and the suction is mounted in the behind-the-head position,
it is a good idea to install the device in a setting.
In this case, the connection opening for the rinsing basin drain must be closed with a blind plug.
Set-up with cover
If it is not possible to install the device directly in the treatment unit, the set-up can also be carried out in
the optionally available cover.
The cover should be mounted on the connection box of the treatment unit. The external display and a
transformer are already integrated in the cover.
2
3 4