PowerBox Systems iGyro SAT Instruction Manual page 4

3. SETTING UP
The following set-up procedure uses a Pioneer simply as an example. The menus
at the PowerBox transmitter are absolutely identical for a PBR receiver or other
PowerBox system.
If you wish to operate the iGyro SAT and a PowerBox with a Jeti system, you will find
the same menu system in your transmitter's JetiBox menu. For pilots using other
systems you will find all the menu points 1:1 the same on the Mobile Terminal. The
same applies to PowerBox systems such as the Royal, Competition or Mercury with
a display connected: the menu system and set-up operations are always the same.
The next part of the procedure varies according to the state of the model, i.e. whether
the model has already been test-flown without a gyro, or is still unflown.
The procedure is also different if you are using a Royal, Competition or Mercury,
since these provide a set-up Assistant on their own display. If you are using any of
these three PowerBox systems it is absolutely essential that you read the operating
instructions supplied with them.
a) New model
- Assigning all model functions, including a channel for gyro gain
- Setting up all model functions (travel, centre, Expo, etc.)
- Test-flying the model, including trims, differential, etc.
- Assigning the gyro outputs
- Setting the installed orientation
- Learning the centre and end-points
- Adjusting the iGyro in flight using the gain adjustor
- Fine-tuning the individual axes, if necessary
- Storing the established gain value on a switch
4 PowerBox-Systems − World Leaders in RC Power Supply Systems