PowerBox Systems iGyro SAT Instruction Manual page 2

The iGyro SAT acts as gyro sensor unit for the iGyro function in a whole range of
our products, including the Royal SR2, Competition SR2, Mercury SR2, Pioneer
and all receivers from the PBR7S up.
When operating, the iGyro SAT supplies sensor data to the device via the FastTrack
bus, and the iGyro software then delivers the requisite signals to the servos. Every
aspect of the set-up phase for all devices can be carried out from the transmitter;
an advantage of the high-performance telemetry system of the Core transmitter.
There are various methods of setting up PowerBox power supply units: from the
transmitter if using a PowerBox or Jeti system, using the Display if connected to
the system, using the Mobile Terminal or even with a PC and USB cable.
The set-up process is simple, and consists of three steps: assigning the channels,
detecting the installed orientation, and establishing the end-points. If Delta or V-tail
mixers are present, they are detected automatically.
Additional features are available, including Attitude Assist, Smart Assist, Stick-
priority and Lock-in feel, and these facilities provide experts with all the tools for
fine-tuning the iGyro to meet their specific needs.
One absolute highlight of all iGyros is that a GPS III or PBS-TAV can be connected
to provide speed-dependent gain control. At the same time these sensors supply
telemetry information!
2. INSTALLATION, CONNECTIONS
In the next section the term primary device is used to denote the receivers or Power-
Boxes in which the iGyro settings are entered.
2 PowerBox-Systems − World Leaders in RC Power Supply Systems