PowerBox Systems iGyro SAT Instruction Manual page 16

- Stickpriority:
This setting enables you to alter the degree of override of the gyro function.
The default setting is 100 %, which means that the gyro function is completely
suppressed when the transmitter stick is at its end-point. However, if you set Stick-
priority to 200 %, for example, then the gyro function is fully suppressed when the
stick is only half-way to its end-point. This makes the model more agile, but at
the same time reduces gyro effect more quickly as the stick is moved away from
centre.
At lower settings the gyro effect is retained for longer when the stick is moved, and
the model feels less responsive.
- Lock-in feel:
This setting affects the response of the gyro after the pilot gives a control input.
The default value is 20 %.
The effect can best be felt during a high-speed four-point roll in which the model
stops quickly at each point. If this value is set too high, the result is that the model
"rolls back" at the moment when the stick is released. If the value is set too low, the
"locking" effect may not be sufficiently pronounced.
- Airspeed Factor:
This value defines the rate at which gyro gain is reduced by a change in airspeed.
The setting only has a function if the model is fitted with a GPS III or a PBS-TAV.
You should increase the Airspeed Factor if the model displays good gyro perfor-
mance at low and medium speed, but tends to oscillate at high speed.
Important: An Airspeed Factor of 5 reduces gyro gain to zero at maximum
speed!
16 PowerBox-Systems − World Leaders in RC Power Supply Systems