Button Board - HP 510 Maintenance And Service Manual

Button board

Description
Button board
Before removing the button board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power cord.
4. Remove the battery (see
5. Remove the memory/Mini PCI card module compartment cover (see
on page
6. Remove the following components:
a. Switch cover (see
b. Keyboard (see
Remove the button board:
1. Release the ZIF connector (1) to which the button board cable is connected and disconnect the
cable (2) from the system board.
2. Remove the Phillips PM2.0×3.0 screw (3) that secures the button board to the computer.
3. Remove the button board (4).
Reverse this procedure to reassemble and install the button board.
ENWW
Battery on page
32).
Switch cover on page
Keyboard on page
29).
38)
40)
Component replacement procedures
Spare part number
441631-001
Memory module
43