Touchpad Cable - HP 510 Maintenance And Service Manual

TouchPad cable

Description
TouchPad cable
Before removing the TouchPad cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power cord.
4. Remove the battery (see
5. Remove the following components:
a. Hard drive (see
b. Memory/Mini PCI card module compartment cover (see
c. Optical drive (see
d. Switch cover (see
e. Keyboard (see
f. Display assembly (see
g. Base enclosure (see
h. Fan assembly (see
i. Heat sink (see
j. System board (see
Remove the TouchPad cable:
1. Position the top cover with the front toward you.
ENWW
Battery on page 29).
Hard drive on page 30)
Optical drive on page
Switch cover on page
Keyboard on page 40)
Display assembly on page
Base enclosure on page
Fan assembly on page
Heat sink on page 53)
System board on page
Spare part number
441638-001
Memory module on page
36)
38)
44)
49)
52)
58)
Component replacement procedures
32)
63