Preset Tutorial - Fractal VP4 Owner's Manual

VP4 OWNER'S MANUAL

Preset Tutorial

Load an Empty Preset
 Change to Preset Mode
 Turn knob A to any <Empty> preset and press ENTER.
Add a Phaser effect
 Turn SELECT until the first effect is highlighted.
 Turn A until the Phaser effect is shown and then press ENTER.
 Press ENTER again to edit the Phaser. The Phaser Types page will appear.
 Turn knob A to highlight the "Script 90" type.
 Press ENTER or Page Right to show the settings for the Phaser.
 We'll start simple. Adjust Rate and Depth however you like them.
 Press EXIT when you're done.
Save the Preset
 Press SAVE.
 We're not going to change the LOCATION but let's edit the NAME.
Turn SELECT to highlight the NAME line.
Use: Cursor (knob A) A-Z, (knob B)
 Enter the name "My VP4". If you make a mistake, PAGE LEFT
and PAGE RIGHT can be used to delete or insert characters.
 Press ENTER twice to commit your changes.
Add a Drive effect
 Turn SELECT until the second effect is highlighted.
 Turn knob B until the Drive effect is shown and then press ENTER.
 Press ENTER again to edit the Drive. The Types page will appear.
 Turn SELECT or knob A to highlight the "T808 OD" type.
 Press ENTER or PAGE RIGHT to show the settings for the Drive.
 Dial in the Drive however you like it and press EXIT when finished.
Save the Preset Again
 Press SAVE, ENTER, ENTER.
PRESETS
a-z (knob C) 0-9 (knob D)
Add Delay and Reverb.
 Use what you've learned to add a Delay block and
a Reverb Block for effects 3 and 4.
 Save the preset when you're done.
You have now created a preset from scratch!
For those who wish to dive deeper into some of the more advanced
functionality offered by just a single VP4 preset, this tutorial continues on
p. 37 with Channels and Scenes.
28