Setup: Classic Pedalboard; Setup: Vp4 With Other Pedals - Fractal VP4 Owner's Manual

VP4 OWNER'S MANUAL

Setup: Classic Pedalboard

Most players will use the VP4 as a classic VIRTUAL PEDALBOARD. For this setup,
connect your guitar to the VP4 L/Mono input. Connect VP4 L/Mono output to the
input of your amp or modeler. Use standard guitar patch cables. Aside from the
usual steps of checking levels and mono/stereo, no special settings are required.
Try banks A-O with this setup.

Setup: VP4 With Other Pedals

The VP4 can also be used before and/or after other pedals. Use standard
guitar patch cables for every connection. Aside from the usual simple steps of
checking levels and mono/stereo settings, no special settings are required.
Try Factory Preset banks Try banks A-O with this setup. If you have a Drive
Pedal in front of the VP4, try banks P–R or any preset marked ">"
DRIVE ME
SETTING UP YOUR RIG
 Connect your guitar to VP4 Input L/Mono
 Connect VP4 Output L/Mono to your amp.
Use VP4 Output R to a second amp for stereo.
 If connecting in front of a modeler, disable its Noise Gate, if possible.
 Connect your guitar or the output of another pedal to VP4 Input L/Mono.
 For stereo input, connect both VP4 inputs, L/Mono and R, and
be sure SETUP > Audio > Input Mode is set to "STEREO".
 Connect VP4 Output L/Mono to the input of your next pedal or amp.
 For stereo input, connect both VP4 outputs, L/Mono and R, and
be sure SETUP > Audio > Output Mode is set to "STEREO".
17