Page 1
Operating and maintenance instructions WAREMA pergola awning Perea Original instructions To be handed over to the opera- tor. Please keep for future use. Valid from 2 June 2023 Document number 2022053 [Rev. 9 - en]...
Table of contents Table of contents Introduction........................3 Information on safety............................ 3 Information on the target group and application of these instructions............3 Explanation of the signal words........................3 Basic safety instructions..........................3 Product information......................6 Intended use..............................6 Parts description............................6 Technical data...............................6 Wind resistance (Pergola awning)........................6 Wind resistance Awning with easyZIP guidance in which pergola awning (optional) is not installed at...
They Incorrect operation can result in personal injury. The describe how to operate products with WAREMA standard movements of the product can lead to crushing of the limbs. drives. Other drives and special solutions are not dealt with.
Page 4
Introduction Operation in the event of a power supply interruption Operation in icy conditions/winter (general procedure) An electrically-operated product cannot be operated without The operation of the product with temperatures around or power. extended product may be subjected to impermissible below the freezing point can lead to malfunctions and/or loads when bad weather fronts pass over or during power damage to property in the case of unfavourable installation...
Page 5
Introduction Duty of supervision when not installed at ground level Freezing of drainage channels in winter If the installation location pergola awning is on a balcony In winter, snowfall may occur. Heat from the sun will begin or a roof terrace, for example, special precautions must be to melt the snow.
Reinforcement profile (fixed) not permitted. WAREMA will not be liable for any ensuing damage. The reinforcement profile has the function of maintaining the distance between the guide rails.
Product information The declared performance only applies to the product itself. The type of installation and the mounting substructure may reduce the maximum permissible wind speed. The maximum permitted wind speed (wind speed limit) for the product when it is extended is: 13 m/s (Beaufort 6) If the maximum permitted wind speed is exceeded, the product must be retracted.
Declaration of performance The product can be equipped with additional The declaration of performance can be functions, such as radiant heaters or light rails. found at (www.warema.de/ce). Before operating the product, read and follow the separate instructions. INFO Small amounts of water may penetrate the cover panel, even while the awning is retracted.
Operation Danger of crushing, shearing and entanglement Movement Operate the switch. The While the product is product moves in the moving, keep persons selected direction. away from the product. While the product is Press the button on the moving, do not reach hand-held transmitter.
Page 10
Operation Operation in wet weather Operation in cold weather or winter INFO NOTICE Water drainage can only be ensured when the Product damage from forceful operation! awning is fully extended. After an impact with condensation water, rain Depending on the size, tolerances and temperature, or snow, the product can freeze up at low small amounts of water may begin to accumulate on temperatures.
WAREMA void. heightened risk of corrosion. Proper and regular cleaning and maintenance and the...
Page 12
The WAREMA cleaning agent for sun shading Low-calcium water (recommendation) products can be used for metal and plastic surfaces WAREMA cleaning agent for sun shading products (do and is certified by the GRM (Gütegemeinschaft not use on wood products) Reinigung von Fassaden e.V.) (certification no.
Page 13
Drying the product extend the product into the lower limit position. Prepare a bucket with water and WAREMA cleaning agent Leave awning fabric that has for sun shading products. become wet to air-dry. Note the dosing quantities specified by the cleaning agent manufacturer.
Personal injury resulting from inappropriate repairs! To ensure proper functioning and your continued Familiarity with the functions and design of the enjoyment of the product, WAREMA recommends having it professionally maintained once a year. product is required to ensure that it can be worked on safely.
Dismantling of the product must be undertaken by The yarn may break. This will lead to knots. Irregular thread a qualified specialist. Ask WAREMA for any missing thicknesses are seen as light areas or burls in the fabric. documents before commencing maintenance.
Troubleshooting Troubleshooting INFO Problems described here without reference to a qualified specialist or certified electrician may be resolved independently. All other problems listed must be handled by a qualified specialist or certified electrician. Fault: The motor is not functioning. Cause Remedy Note The thermal protection switch on the...
Used for motor drives without an integrated radio receiver. Directive on radio equipment 2014/53/EU (RED): Use for motor drives with an integrated radio receiver or for WAREMA components with an integrated radio receiver. Person in charge of the compilation of the technical documents: Elke Granzer; for address, see manufacturer.
Need help?
Do you have a question about the Perea P60 and is the answer not in the manual?
Questions and answers