Table of Contents
Related Manuals for WAREMA Terrea H60
Summary of Contents for WAREMA Terrea H60
- Page 1 Operating and maintenance instructions WAREMA articulated arm awning Terrea H60 / G60 Original instructions To be handed over to the opera- tor. Please keep for future use. Valid from 1 September 2023 Document number 2014710 [Rev. 3 - en]...
-
Page 2: Table Of Contents
Table of contents Table of contents Introduction........................3 Information on safety............................ 3 Information on the target group and application of these instructions............3 Explanation of the signal words........................3 Basic safety instructions..........................3 Product information......................5 Intended use..............................5 Parts description............................5 Electric drive data............................ -
Page 3: Introduction
The instructions contain important information on the Possible risk during operation operation, care and maintenance of this item. They describe how to operate products with WAREMA standard Incorrect operation can result in personal injury. The drives. Other drives and special solutions are not dealt with. - Page 4 Introduction Operation in the event of a power supply interruption Operation in icy conditions/winter (general procedure) An electrically-operated product cannot be operated The operation of the product with temperatures around or without power. A extended product may be subjected to below the freezing point can lead to malfunctions and/or impermissible loads when bad weather fronts pass over damage to property in the case of unfavourable installation...
-
Page 5: Product Information
≤ 70 dB(A). This value may vary depending on the it to become detached from the wall and are therefore specific installation. not permitted. WAREMA will not be liable for any ensuing INFO damage. The table above shows a summary of the permissible motors. -
Page 6: Wind Resistance
The product moves in the selected direction. Declaration of performance The declaration of performance can be found at (www.warema.de/ce). INFO The product has an upper and lower limit position. The product automatically stops at this point. The product can be stopped in any position. -
Page 7: Product With Crank
Operation Product with additional turning gear INFO of the motors used are not intended for continuous INFO operation. Turning the crank on the turning gear allows the The integrated thermal protection switches the motor product's inclination to be adjusted over a range of off after approx. -
Page 8: Valance Roller Blind With Crank
Operation Danger of crushing, shearing and entanglement Movement with comfort control Brief keystroke: awning While the product is moves. moving, keep persons away from the product. Long keystroke: valance roller blind moves. While the product is moving, do not reach 2 brief keystrokes: between the moving awning/valance roller... -
Page 9: Service
Use of the product in a manner that is not intended or failure to care for and check the product improperly render Moisture promotes wrinkling and waffling. the product warranty from WAREMA void. Once the rain has stopped, awning fabric that has become wet should be extended so that it Proper and regular cleaning and maintenance and the can dry. - Page 10 It is important to abide by the interval of one year. Tip/recommendation Using the WAREMA cleaning glove together with Purpose of cleaning and care WAREMA cleaning agent concentrate for sun shading products is an ideal way to properly clean The benefit provided by regular and proper cleaning and product surfaces.
- Page 11 Vacuum cleaner (optional) the procedure as needed based Bucket on the degree of soiling. Low-calcium water (recommendation) WAREMA cleaning agent for sun shading products (do not use on wood products) WAREMA cleaning glove Remove the detached soiling Cotton cloth before drying.
-
Page 12: Maintenance
Drying the product INFO To ensure proper functioning and your continued extend the product into the lower limit position. enjoyment of the product, WAREMA recommends having it professionally maintained once a year. Leave awning fabric that has Information on this can be obtained from become wet to air-dry. -
Page 13: Repair
Guideline for the Evaluation of Preassembled Dismantling of the product must be undertaken by Awning Fabrics – published by the ITRS Industrieverband a qualified specialist. Ask WAREMA for any missing Technische Textilien Rollladen - Sonnenschutz e. V.]: documents before commencing maintenance. - Page 14 Dismantling/disposal INFO Electrically operated products contain integrated electrical or electronic components, such as the motor, control and lines. These components must be removed and disposed of separately from the product as described below (Disposal). WARNING Electric shock! When working in the immediate vicinity of potentially live parts, such as electrical lines, contact may result in an electric shock.
-
Page 15: Troubleshooting
Troubleshooting Troubleshooting INFO Problems described here without reference to a qualified specialist or certified electrician may be resolved independently. All other problems listed must be handled by a qualified specialist or certified electrician. Fault: the motor is not functioning Cause Remedy Note The thermal protection switch on the... -
Page 16: Declaration Of Conformity
Used for motor drives without an integrated radio receiver. Directive on radio equipment 2014/53/EU (RED): Use for motor drives with an integrated radio receiver or for WAREMA components with an integrated radio receiver. Person in charge of the compilation of the technical documents: Elke Granzer; for address, see manufacturer.
Need help?
Do you have a question about the Terrea H60 and is the answer not in the manual?
Questions and answers