Subscribe to Our Youtube Channel
Related Manuals for WAREMA Perea P40
Summary of Contents for WAREMA Perea P40
- Page 1 Operating and maintenance instructions WAREMA pergola awning Perea P40/P40 WeatherEdition Original instructions To be handed over to the opera- tor. Please keep for future use. Valid from 2 June 2023 Document number 2004017 [Rev. 19 - en]...
-
Page 2: Table Of Contents
Technical data...............................6 Wind resistance............................6 Resistance against water collection......................7 Declaration of performance.......................... 7 Operation.......................... 7 Product with lowerable pole (only Perea P40).....................7 Product with motor............................8 Valance roller blind (optional)/(Perea P40 only)...................8 Incorrect operation............................9 Service..........................11 Cleaning, care and inspection activities.....................11 Maintenance..............................14... -
Page 3: Introduction
These instructions are an integral part of the following stop using it immediately and inform a qualified product: specialist. pergola awning Perea P40 / pergola awning Perea P40 WeatherEdition Possible risk during operation The instructions contain important information on the Incorrect operation can result in personal injury. - Page 4 Operation in wet weather Risk of damage to the product Under certain conditions, the product Perea P40 can An additional load can damage the product and/or cause it be used as a form of rain protection (depending on the to detach from its mount.
-
Page 5: Product Information
Intended use Parts description The following details apply to the following product: pergola awning Perea P40 / pergola awning Perea P40 WeatherEdition Information on Perea P40 The product is an external sun shading system that may be used for thermal protection and glare control. -
Page 6: Technical Data
Product information Travelling reinforcement profile (only for Perea P40) Magnets are mounted on both sides of the front rail. Magnets are mounted on the bearing parts of the travelling reinforcement profile. Following the functional check, the magnets are in contact when the product is retracted. -
Page 7: Resistance Against Water Collection
P40, curved guide rail NOTICE Product damage from forceful operation! Perea P40 WeatherEdition The product provides rain protection beginning at an When operating the product, excessive force must inclination angle of 9° (corresponds to the smallest angle not be applied to the operating element if any that can be ordered). -
Page 8: Product With Motor
Operation using a central control unit NOTICE Valance roller blind (optional)/(Perea P40 Product damage from incorrect setting of the control only) unit for pergola awnings P40 with a lowerable pole! -
Page 9: Incorrect Operation
Operation Valance roller blind with crank NOTICE Product damage when the lower limit position is overrun! The valance roller blind does not have a limit stop < 2000 in the lower limit position. After the order height is > 2000 reached, the valance roller blind is raised again in the wrong direction. - Page 10 In the event of rain, re- tract and do not extend the product Perea P40. In the event of hail, re- tract and do not extend the product Perea P40 WeatherEdition.
-
Page 11: Service
Use of the product in a manner that is not intended or failure to care for and check the product improperly render After an impact with condensation water, rain the product warranty from WAREMA void. or snow, the product can freeze up at low temperatures. - Page 12 Service INFO Tip/recommendation The activities described in this section can be Using the WAREMA cleaning glove together with performed by the operator. It is important to abide by WAREMA cleaning agent concentrate for sun the interval of one year. shading products is an ideal way to properly clean product surfaces.
- Page 13 Vacuum cleaner (optional) the procedure as needed based Bucket on the degree of soiling. Low-calcium water (recommendation) WAREMA cleaning agent for sun shading products (do not use on wood products) WAREMA cleaning glove Remove the detached soiling Cotton cloth before drying.
-
Page 14: Maintenance
INFO To ensure proper functioning and your continued INFO enjoyment of the product, WAREMA recommends To prevent scale marks from forming around dried having it professionally maintained once a year. water droplets, the surfaces of the product can be rubbed dry using a microfibre or cotton cloth. -
Page 15: Repair
(humidity, rain). If a fabric that has been status, only use original spare parts. "softened" in this way is retracted, waffling and wrinkles can To order, contact your WAREMA dealer. become particularly pronounced. Weave flaws Spare parts... -
Page 16: Dismantling/Disposal
Have the units dismantled by a qualified specialist. Dismantling of the product must be undertaken by a qualified specialist. Ask WAREMA for any missing documents before commencing maintenance. INFO Electrically operated products contain integrated electrical or electronic components, such as the motor, control and lines. -
Page 17: Troubleshooting
Troubleshooting Troubleshooting INFO Problems described here without reference to a qualified specialist or certified electrician may be resolved independently. All other problems listed must be handled by a qualified specialist or certified electrician. Fault: The motor is not functioning. Cause Remedy Note The thermal protection switch on the... - Page 18 Troubleshooting Fault: awning with WMS sensor retracts automatically Cause Remedy Note The wind alarm was trigger. Wait for the on/off delay and then try again. The wind alarm was triggered by an Wait for the on/off delay and then try impact against the pole.
-
Page 19: Declaration Of Conformity
Used for motor drives without an integrated radio receiver. Directive on radio equipment 2014/53/EU (RED): Use for motor drives with an integrated radio receiver or for WAREMA components with an integrated radio receiver. Person in charge of the compilation of the technical documents: Elke Granzer; for address, see manufacturer. - Page 20 WAREMA Renkhoff SE Hans-Wilhelm-Renkhoff-Straße 2 97828 Marktheidenfeld Germany www.warema.com info@warema.com...
Need help?
Do you have a question about the Perea P40 and is the answer not in the manual?
Questions and answers