Page 1
Operating and maintenance instructions WAREMA cassette awning Terrea K70 / K50 Original instructions To be handed over to the opera- tor. Please keep for future use. Valid from 1 September 2023 Document number 2006212 [Rev. 8 - en]...
Table of contents Table of contents Introduction........................3 Information on safety............................ 3 Information on the target group and application of these instructions............3 Explanation of the signal words........................3 Basic safety instructions..........................3 Product information......................5 Intended use..............................5 Parts description............................5 Electric drive data............................
If the product makes unusual noises or movements, These instructions are an integral part of the following stop using it immediately and inform a qualified product: cassette awning Terrea K70 / K50 specialist. The instructions contain important information on the Possible risk during operation operation, care and maintenance of this item.
Page 4
Introduction Operation in the event of a power supply interruption Operation in icy conditions/winter (general procedure) An electrically-operated product cannot be operated The operation of the product with temperatures around or without power. A extended product may be subjected to below the freezing point can lead to malfunctions and/or impermissible loads when bad weather fronts pass over damage to property in the case of unfavourable installation...
Short-term operation (S2) 4 min it to become detached from the wall and are therefore LpA ≤ 70 dB(A) not permitted. WAREMA will not be liable for any ensuing Emissions sound pressure level damage. The sound pressure level LpA in a standard installation of the product on a test stand is The intended use also includes observing these instructions ≤ 70 dB(A).
Declaration of performance The declaration of performance can be Press the button on the hand-held transmitter. found at (www.warema.de/ce). The product moves in the selected direction. INFO The product has an upper and lower limit position. The product automatically stops at this point.
The integrated thermal protection switches the motor INFO off after approx. 4 minutes. The product will be ready Only pertains to cassette awning Terrea K70. again for use after 10 to 15 minutes. Adjust the control unit in such a way that Movement with basic control continuous operation of the motor is not possible.
Operation Valance roller blind with crank Danger of crushing, shearing and entanglement NOTICE While the product is Product damage from forceful operation! moving, keep persons away from the product. When operating the product, excessive force must While the product is not be applied to the operating element if any moving, do not reach resistance is encountered.
Use of the product in a manner that is not intended or failure to care for and check the product improperly render Moisture promotes wrinkling and waffling. the product warranty from WAREMA void. Once the rain has stopped, awning fabric that has become wet should be extended so that it Proper and regular cleaning and maintenance and the can dry.
Page 10
It is important to abide by the interval of one year. Tip/recommendation Using the WAREMA cleaning glove together with Purpose of cleaning and care WAREMA cleaning agent concentrate for sun shading products is an ideal way to properly clean The benefit provided by regular and proper cleaning and product surfaces.
Page 11
Vacuum cleaner (optional) the procedure as needed based Bucket on the degree of soiling. Low-calcium water (recommendation) WAREMA cleaning agent for sun shading products (do not use on wood products) WAREMA cleaning glove Remove the detached soiling Cotton cloth before drying.
Drying the product INFO To ensure proper functioning and your continued extend the product into the lower limit position. enjoyment of the product, WAREMA recommends having it professionally maintained once a year. Leave awning fabric that has Information on this can be obtained from become wet to air-dry.
Guideline for the Evaluation of Preassembled Dismantling of the product must be undertaken by Awning Fabrics – published by the ITRS Industrieverband a qualified specialist. Ask WAREMA for any missing Technische Textilien Rollladen - Sonnenschutz e. V.]: documents before commencing maintenance.
Page 14
Dismantling/disposal INFO Electrically operated products contain integrated electrical or electronic components, such as the motor, control and lines. These components must be removed and disposed of separately from the product as described below (Disposal). WARNING Electric shock! When working in the immediate vicinity of potentially live parts, such as electrical lines, contact may result in an electric shock.
Troubleshooting Troubleshooting INFO Problems described here without reference to a qualified specialist or certified electrician may be resolved independently. All other problems listed must be handled by a qualified specialist or certified electrician. Fault: the motor is not functioning Cause Remedy Note The thermal protection switch on the...
Page 16
Troubleshooting Fault: the cassette does not close properly Cause Remedy Note The console lock was not firmly tight- Retighten the console locks. Adjustment by qualified specialist ened Page 16 | 18 2006212 [Rev. 8 - en]/2023-09-01...
Used for motor drives without an integrated radio receiver. Directive on radio equipment 2014/53/EU (RED): Use for motor drives with an integrated radio receiver or for WAREMA components with an integrated radio receiver. Person in charge of the compilation of the technical documents: Elke Granzer; for address, see manufacturer.
Need help?
Do you have a question about the Terrea K70 and is the answer not in the manual?
Questions and answers