Advertisement
Quick Links
Mounting instructions DMZ210 / DMZ010
Full-frame pedestal with screw-on tube with placement hinge, for type MEZZO /
DACAPO / FILIUS
The following instructions include all information necessary for the assembly and operation of this
frame pedestal. To avoid any misunderstanding we advise you to read these instructions carefully
and then keep them for later reference.
Non- observation of mounting instructions can result in personal injuries
or damage to property.
Please note that if these instructions are not observed, the manufacturer cannot
Caution
assume any liability or guarantee.
Always follow the safety regulations.
Should you not understand any part of these mounting instructions, please
contact your MAY dealer.
Diagram showing mounting materials and tools
Stand 36-2244
bore hole for theft and anti-twisting lock
hex socket head screw M12 x 20 mm +
serrated lock washer
frame pedestal
base clamp
English
placement hinge
page 1 of 9
Advertisement
Related Manuals for MAY DMZ210
Summary of Contents for MAY DMZ210
- Page 1 Mounting instructions DMZ210 / DMZ010 Full-frame pedestal with screw-on tube with placement hinge, for type MEZZO / DACAPO / FILIUS The following instructions include all information necessary for the assembly and operation of this frame pedestal. To avoid any misunderstanding we advise you to read these instructions carefully and then keep them for later reference.
- Page 2 wooden planking concrete foundation Stand 36-2244 English page 2 of 9...
- Page 3 Set the torque wrench to 25 Nm for the hex socket head screw M8x20mm. 2. Choose the location for your DMZ210 / DMZ010. Put the placement hinge in a position that will allow enough space for the parasol to be erected and dismounted.
- Page 4 10 cm gradation. These can be adjusted in height on location with the help of inside spacers. 5. When setting the DMZ210 / DMZ010, make sure that the frame pedestal of the bottom component is (almost) flush (-3 mm) with the terrace floor surface.
- Page 5 A falling parasol can cause serious or even fatal injury. If the number of concrete slabs in the frame does not correspond with the size of the umbrella, the parasol may fall and cause injuries. Attention Observe the information given in the above chart.
-
Page 6: Power Supply (Optional)
concrete slab Power supply (optional) 1. Press the flexible connecting rubber lead (certified approval for outdoor use necessary) through the cable gland and tighten the nut so that the rubber is narrowed and tension relief is provided. cable gland flexible rubber lead Stand 36-2244 English page 6 of 9... - Page 7 (or the like) to make it 100% waterproof. Fire hazard. Do not use a dimmer switch. Otherwise the sunshade may catch fire. If the sunshade is equipped with a timer switch or automatic switch off, a dimmer will interfere with the electrical system.
- Page 8 3. Screw the top plate onto the lower anchor tube. (cf. illus.) The thread can get damaged. When the top plate is not on the lower anchor tube, sand may get washed into the flanks of the thread. As sand is harder than steel, the thread may get damaged Caution when the screw is turned.
-
Page 9: Project Management
In case this installation option is found not to be suitable, you may select another option from the MAY program. Customized options are available upon request depending on complexity. - Page 10 Full frame pedestal with placement hinge DMZ210 This order sheet must be filled out completely and supplied to the MAY company before production. For 1 set of standard concrete slabs 40x40x5 cm. Art. no. DMZ210: 2 pieces, screw-off upper part, fits for pole ø 55 mm upper part, standard length 25 cm art.
- Page 11 Full frame pedestal with placement hinge DMZ210 This order sheet must be filled out completely and supplied to the MAY company before production. Lower part of DMZ210 (350779) with top plate for winter protection. All bases are custom-made. When ordering, please state the total height required, including winter top plate (due to space constraints, the illustration is cut).
- Page 12 Full frame pedestal with placement hinge DMZ010 This order sheet must be filled out completely and supplied to the MAY company before production. For 1 set of standard concrete slabs 40x40x5 cm. Art. no. DMZ010: 2 pieces, screw-off upper part, fits for pole ø 55 mm upper part, standard length 25 cm art.
- Page 13 - 100 mm with 1 layer concrete slabs. - 150 mm with 2 layer concrete slabs. In case the „height of the lower part“ needs to be larger than 300 mm, option DMZ210 must be used. Customized versions with adjustable feet increase the height about approximately 25 mm.
Need help?
Do you have a question about the DMZ210 and is the answer not in the manual?
Questions and answers