Dual-Purpose Port Leds; Cable Guard; Rear Panel Description - Cisco WS-C3560-48PS-S Hardware Installation Manual

Chapter 1 Product Overview

Dual-Purpose Port LEDs

The LEDs on a dual-purpose port (see
whether an SFP module is installed. You can configure each port as either a 10/100/1000 port through
the RJ-45 connector or as an SFP module, but not both at the same time. The LEDs show how the port
is being used.
The LED colors have the same meaning as described in
Figure 1-13
1
2

Cable Guard

You can order an optional cable guard to secure cables to the front of the switch and prevent them from
being accidentally removed. To order a cable guard (CBLGRD-C3560-12PC or CBLGRD-C3560-8PC),
contact your Cisco representative. The cable guard serves a different purpose than the cable guide (see
"Attaching the Cable Guide" section on page

Rear Panel Description

•
•
•
•
The Catalyst 3560-8PC and the Catalyst 3560-12PC-S switches do not have an RPS connector or a fan.
Note
The switch console port is on the front panel.
OL-6337-07
Dual-Purpose Port LEDs
1 2 3 4
1
3
RJ-45 connector SFP module port LED
4
RJ-45 port LED SFP module slot
Internal Power Supply, page 1-18
Cisco RPS, page 1-19
Console Port, page 1-19
Security Slots, page 1-20
Figure 1-13) show whether the RJ-45 connector is connected or
Table 1-4
2-11).
Catalyst 3560 Switch Hardware Installation Guide
Rear Panel Description
to Table 1-6.
1-15