Where To Go Next - Cisco WS-C3560-48PS-S Hardware Installation Manual

Where to Go Next

Figure 3-14
Insert the securing clip in the opening of the bushing (see
Step 6
Figure 3-15
After the power cord is correctly secured, it looks like this:
Where to Go Next
If the default configuration is satisfactory, the switch does not need further configuration. You can use
any of these management options to change the default configuration:
•
•
•
•
Catalyst 3560 Switch Hardware Installation Guide
3-20
Rotate the Bushing Clockwise
Insert the Securing Clip
Start the device manager, which is in the switch memory, to manage individual switches. The device
manager is a web interface that offers quick configuration and monitoring. You can access the
device manager from anywhere in your network through a web browser. For more information, see
the device manager online help.
Start the Network Assistant application, which is described in the Getting Started with Cisco
Network Assistant guide. Through this GUI, you can configure and monitor a switch cluster or an
individual switch.
Use the CLI from the console to configure the switch as a member of a cluster or as an individual
switch. See the Catalyst 3560 Switch Software Configuration Guide and the Catalyst 3560 Switch
Command Reference on Cisco.com for information on using the CLI with a Catalyst 3560 switch.
Start an SNMP application such as the CiscoView application.
Chapter 3 Switch Installation (8- and 12-Port Switches)
Figure 3-15).
OL-6337-07