Connecting To Fiber-Optic Sfp Modules - Cisco WS-C3560-48PS-S Hardware Installation Manual

Chapter 2 Switch Installation (24- and 48-Port Switches)
Reconfigure and reboot the connected device, if necessary.
Step 3
Repeat Steps 1 through 3 to connect each device.
Step 4

Connecting to Fiber-Optic SFP Modules

Class 1 laser product. Statement 1008
Warning
Do not remove the rubber plugs from the SFP module port or the rubber caps from the fiber-optic cable
Caution
until you are ready to connect the cable. The plugs and caps protect the SFP module ports and cables
from contamination and ambient light.
Before connecting to the SFP module, be sure that you understand the port and cabling stipulations in
the
Specifications,"
Remove the rubber plugs from the module port and fiber-optic cable, and store them for future use.
Step 1
Insert one end of the fiber-optic cable into the SFP module port (see
Step 2
Figure 2-19
1
Insert the other cable end into a fiber-optic connector on a target device.
Step 3
Step 4 Observe the port status LED.
•
•
OL-6337-07
"Installation Guidelines" section on page
for information about the LC on the SFP module.
Connecting to a Fiber-Optic SFP Module Port
4 0
4 1
4 2
4 3
4 4
4 5
4 6
1
LC connector
The LED turns green when the switch and the target device have an established link.
The LED turns amber while the STP discovers the network topology and searches for loops. This
process takes about 30 seconds, and then the port LED turns green.
2-5. See Appendix B, "Connector and Cable
C a t a ly s t
3 5 6 0
4 7
4 8
P o E - 4 8
S E R IE S
47 X
1
3
48 X
2
4
Catalyst 3560 Switch Hardware Installation Guide
Connecting the Switch to Compatible Devices
Figure 2-19).
2-21