Installing Sfp Modules Into Sfp Module Slots - Cisco WS-C3560-48PS-S Hardware Installation Manual

Installing and Removing SFP Modules

Installing SFP Modules into SFP Module Slots

Figure 2-13
Figure 2-13
We strongly recommend that you do not install or remove fiber-optic SFP modules with cables attached
Caution
because of the potential damage to the cables, the cable connector, or the optical interfaces in the
SFP module. Disconnect all cables before removing or installing an SFP module.
Removing and installing an SFP module can shorten its useful life. Do not remove and insert SFP
modules more often than is absolutely necessary.
Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the chassis.
Step 1
Find the send (TX) and receive (RX) markings that identify the top side of the SFP module.
Step 2
Note
Align the SFP module in front of the slot opening.
Step 3
Insert the SFP module into the slot until you feel the connector on the module snap into place in the rear
Step 4
of the slot. (See
Figure 2-14
Catalyst 3560 Switch Hardware Installation Guide
2-16
shows an SFP module that has a bale-clasp latch.
SFP Module with a Bale-Clasp Latch
On some SFP modules, the send and receive (TX and RX) markings might be replaced by arrows
that show the direction of the connection, either send or receive (TX or RX).
Figure 2-14.)
Installing an SFP Module into an SFP Module Slot
40
41
42
43
44
45 C a ta ly s t
46
47
48
47 X
48 X
2
Chapter 2
3 5 6 0
S E R IE S P o E -4 8
1
3
4
Switch Installation (24- and 48-Port Switches)
OL-6337-07