Making Atm Connections - Cisco EF4116 Hardware Installation And Maintenance Manual

Step 9
Step 10
Step 11
Refer to the printed Router Products Configuration Guide and Router Products Command Reference
publications or UniverCD for a summary of the configuration options available and instructions for
configuring the CE1.

Making ATM Connections

If you installed a new ATM interface module or if you want to change the configuration of an
existing module, you must enter the configuration mode. If you replaced the ATM interface that was
previously configured, the system will recognize the new interface and bring it up in the existing
configuration.
After you verify that the new interface is recognized by the router, use the privileged-level configure
command to configure the new ATM module. You will need the following information:
•
•
•
•
The following steps show a basic ATM configuration using just PVCs.
Step 1
Step 2
Step 3
Step 4
Write the new configuration to memory as follows:
Router# write memory
The system will display an OK message when the configuration is stored.
Exit the privileged level and return to the user level by entering disable at the prompt as
follows:
Router# disable
Router>
Check the interface configuration with show commands.
ATM transceiver framing type (STS-3c or STM-1),
Network protocol addresses,
PVC connections and their attributes,
Static address mappings (address-lists).
At the privileged-mode prompt, enter the configuration mode and specify that the console
terminal will be the source of the configuration subcommands:
Router# conf t
Specify the unit to configure by entering the subcommand int, followed by atm and the unit
number. The example that follows is for the ATM unit 0:
Router(config)# int atm 0
Specify the framing type (for SONET interfaces, STS-3c is the default):
Router(config-if)#atm sonet stm-1
Assign protocol addresses to the interface:
Router(config-if)# ip address 1.1.1.1 255.255.255.0
Making Network Connections
Installing the Router 3-17