Making Fddi Network Connections - Cisco EF4116 Hardware Installation And Maintenance Manual

Host Power Supply Requirements
The power requirements of the BRI network processor module are as follows:
•
•
•
Ensure that the power drawn by the apparatus, together with the power drawn by any auxiliary
apparatus, lies within the rating of the host chassis power supply.
Additional Safety Information
The BRI network processor modules contain safety extra-low voltage (SELV) circuitry. Ensure that
attachments at the interconnection ports of the apparatus are also SELV circuits. (SELV circuits are
so designed and protected that, under both normal conditions and a likely fault condition, the current
which can be drawn is not hazardous).
Always disconnect the host chassis from the power supply before removing any covers.
Always disconnect the host chassis from any analog telephone circuits or Basic Access ISDN (where
applicable) before removing any covers.
Failure to install the BRI modules in accordance with these instructions will invalidate any
telecommunication terminal equipment type approval(s).
If you have any doubt as to how to safely install the Cisco Systems BRI module correctly within a
host chassis, seek advice from a qualified telecommunications engineer.

Making FDDI Network Connections

Follow these procedures to make Fiber Distributed Data Interface (FDDI) connections.
Dual-Attachment FDDI Connections
Connect a dual-attachment FDDI module as follows:
Step 1
+5 VDC/2.5 mA
+12 VDC/100 mA
–12 VDC/100 mA
To connect to a dual-attachment station (DAS), connect PHY-A on the FDDI module (the
bottom port) to PHY-B on the other DAS using a multimode fiber-optic cable.
(See Figure 3-10.)
Making Network Connections
Installing the Router 3-11