iRobot Roomba Combo j8 Enhanced Owner's Manual page 17

Cleaning the filter
1
Remove the bin. Remove the filter by grasping
both ends and pulling out.
EN
2
Remove debris by tapping the filter against your
trash container.
3
Reinsert filter with ridged grips facing out. Place
bin back in the robot.
NOTE: The robot will not run if the filter
is not installed correctly. Replace the
filter every two months.
16 For more information, visit global.irobot.com
Cleaning the Edge-Sweeping Brush
1
Use a coin or small screwdriver to remove
the screw holding the Edge-Sweeping
Brush in place.
2
Pull to remove the Edge-Sweeping Brush.
Remove any hair or debris, then reinstall
the brush.
Cleaning the front caster wheel
1
Pull firmly on the front wheel module to remove it
from the robot.
2
Pull firmly on the wheel to remove it from its
housing (see illustration below).
3
Remove any debris from inside the wheel cavity.
4
Reinstall all parts when finished. Make sure the
wheel clicks back into place.
Axle
Housing
IMPORTANT: A front wheel clogged with
hair and debris could result in damage
to your floor. If the wheel is not spinning
freely after you have cleaned it, please
contact Customer Care.
Wheel