Default Switch Configuration - Cisco 4500M Software Manual

Configuring the Switch for the First Time
This chapter describes how to initially configure a Catalyst 4500 series switch. The information
presented here supplements the administration information and procedures in these publications:
•
•
This chapter includes the following major sections:
•
•
•
•
•
•
For complete syntax and usage information for the switch commands used in this chapter, refer to the
Note
Catalyst 4500 Series Switch Cisco IOS Command Reference and related publications at
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/index.htm

Default Switch Configuration

This section describes the default configurations for the Catalyst 4500 series switch.
default configuration settings for each feature.
Table 3-1
Feature
Administrative connection
Global switch information
System clock
OL-6696-01
Cisco IOS Configuration Fundamentals Configuration Guide, Release 12.2, at this URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fun_c/index.htm
Cisco IOS Configuration Fundamentals Configuration Command Reference, Release 12.2, at this
URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fun_r/index.htm
Default Switch Configuration, page 3-1
Configuring DHCP-Based Autoconfiguration, page 3-2
Configuring the Switch, page 3-8
Controlling Access to Privileged EXEC Commands, page 3-13
Recovering a Lost Enable Password, page 3-18
Modifying the Supervisor Engine Startup Configuration, page 3-18
Default Switch Configuration
C H A P T E R
Default Settings
Normal mode
No default value for system name, system contact, and location
No value for system clock time
Software Configuration Guide—Release 12.2(25)EW
3
Table 3-1 shows the
3-1