Cisco 4500M Software Manual page 149

Chapter 9 Configuring Switches with Web-based Tools
interface GigabitEthernet3/8
!
interface GigabitEthernet3/9
shutdown
!
interface GigabitEthernet3/10
shutdown
!
interface GigabitEthernet3/11
shutdown
interface Vlan1
no ip address
!
interface Vlan100
no ip address
!
ip http server
Enable Intra-Cluster Communication
You can use the following interfaces for intra-cluster communication: a router, an switched virtual
interface (SVI), an access port, or a trunk port. If you employ an access port or trunk port, the VLAN
used for inter-cluster communication must have an SVI in the no shut state.
To enable inter-cluster communication, perform this task on each of the Catalyst 4500 series switches
that will serve as cluster member candidates.
Command
Step 1
Switch# configuration terminal
Step 2
Switch(config)# cluster run
Step 3
Switch(config)# vlan vlan_id
Step 4
Switch(config-vlan)# no shutdown
Step 5
Switch(config)# interface {vlan vlan_ID |
{fastethernet | gigabitethernet}
slot/interface
Step 6
Switch(config-if)# no shutdown
Step 7
Switch(config)# interface {vlan vlan_ID |
{fastethernet | gigabitethernet}
slot/interface
Step 8
Switch(config-if)# switchport mode access
Step 9
Switch(config-if)# switchport access vlan
vlan-id
Step 10
Switch(config-if)# end
Step 11
Switch# show running-config
OL-6696-01
|
Port-channel number }
|
Port-channel number }
Configuring and Using the Network Assistant
Purpose
Enters global configuration mode.
Enables clustering.
Enable clustering on all switches that are part of the
Note
potential cluster.
Specifies a VLAN used to communicate with the cluster
command switch.
Enables a VLAN interface.
Selects an interface.
Enables the interface.
Selects a port interface.
Configures the port interface as an access port.
Assigns the port interface to a VLAN.
Returns to privileged EXEC mode.
Verifies the configuration.
Software Configuration Guide—Release 12.2(25)EW
9-7