Monitoring And Maintaining Tunneling Status - Cisco 4500M Software Manual

Monitoring and Maintaining Tunneling Status

Switch(config-if)# l2protocol-tunnel shutdown-threshold 1500
Switch(config-if)# l2protocol-tunnel drop-threshold 1000
Switch(config-if)# exit
Switch(config)# l2protocol-tunnel cos 7
Switch(config)# end
Switch# show l2protocol
COS for Encapsulated Packets: 7
Port
------- -------- --------- --------- ------------- ------------- -------------
Fa2/11
Monitoring and Maintaining Tunneling Status
Table 19-2
Table 19-2 Commands for Monitoring and Maintaining Tunneling
Command
Switch# clear l2protocol-tunnel counters
Switch# show dot1q-tunnel
Switch# show dot1q-tunnel interface
interface-id
Switch# show l2protocol-tunnel
Switch# show errdisable recovery
Switch# show l2protocol-tunnel interface
interface-id
Switch# show l2protocol-tunnel summary
Switch# show vlan dot1q native
With Release 12.2(20)EW, the BPDU filtering configuration for both dot1q and Layer 2 protocol
Note
tunneling is no longer visible in the running configuration as "spanning-tree bpdufilter enable." Instead,
it is visible in the output of the show spanning tree int detail command as shown below.
Switch# show spann int f6/1 detail
Port 321 (FastEthernet6/1) of VLAN0001 is listening
Port path cost 19, Port priority 128, Port Identifier 128.321.
Designated root has priority 32768, address 0008.e341.4600
Designated bridge has priority 32768, address 0008.e341.4600
Designated port id is 128.321, designated path cost 0
Timers: message age 0, forward delay 2, hold 0
Number of transitions to forwarding state: 0
Link type is point-to-point by default
** Bpdu filter is enabled internally **
BPDU: sent 0, received 0
Software Configuration Guide—Release 12.2(25)EW
19-12
Protocol Shutdown Drop
Threshold Threshold Counter
cdp 1500
stp 1500
vtp 1500
shows the commands for monitoring and maintaining 802.1Q and Layer 2 protocol tunneling.
Purpose
Clears the protocol counters on Layer 2 protocol tunneling ports.
Displays 802.1Q tunnel ports on the switch.
Verifies if a specific interface is a tunnel port.
Displays information about Layer 2 protocol tunneling ports.
Verifies if the recovery timer from a Layer 2 protocol-tunnel error disable
state is enabled.
Displays information about a specific Layer 2 protocol tunneling port.
Displays only Layer 2 protocol summary information.
Displays the status of native VLAN tagging on the switch.
Chapter 19 Configuring 802.1Q and Layer 2 Protocol Tunneling
Encapsulation Decapsulation Drop
Counter
1000 2288 2282
1000 116 13
1000 3 67
Counter
0
0
0
OL-6696-01