Displaying The Poe Consumed By A Module - Cisco 4500M Software Manual

Chapter 8 Configuring Power over Ethernet
Fa3/12
Fa3/13
Fa3/14
Fa3/15
Fa3/16
Fa3/17
Fa3/18
--------- ------ ---------- ---------- ---------- ------------------- -----
Totals:
Switch#
This example shows how to display the operational status for Fast Ethernet interface 4/1:
Switch#show power inline fa4/1
Available:677(w)
Interface Admin
--------- ------ ---------- ---------- ---------- ------------------- -----
Fa4/1
Interface
---------- --------------- --------------------
Fa4/1
Switch#

Displaying the PoE Consumed by a Module

The switch can measure the actual PoE consumption for an 802.3af-compliant PoE module, and it
displays the measured PoE in both the show power module and show power detail commands.
However, the switch cannot display the consumption of an individual interface on an 802.3af-compliant
PoE module, nor can it measure the actual PoE consumption for the WS-X4148-RJ45V module.
Therefore, for all PoE calculations, the PoE consumption on the WS-X4148-RJ45V module is presumed
to be equal to its administrative PoE.
The 802.3af-compliant PoE modules can consume up to 20 W of PoE to power FPGAs and other
hardware components on the module. Be sure to add at least 20 W to your PoE requirements for each
802.3af-compliant PoE module to ensure that the system has adequate power for the PDs connected to
the switch.
The example below displays the PoE consumption for an 802.3af-compliant module using the show
power module command.
The "Inline Power Oper" column displays the amount of PoE consumed by the powered devices that are
attached to the module, in addition to the PoE consumed by the FPGAs and other hardware components
on the module. The "Inline Power Admin" column displays only the amount of PoE allocated by the
powered devices attached to the module.
The operating PoE consumption for an 802.3af-compliant module can be non-zero, even when there are
Note
no powered devices attached to the module, because of the PoE consumed by FPGAs and other hardware
components on the module. In addition, the operating PoE can vary due to fluctuations in the PoE
consumed by the hardware components.
OL-6696-01
auto off 0
auto off 0
auto off 0
auto off 0
auto off 0
auto off 0
auto off 0
10 on 117.5
Used:11(w) Remaining:666(w)
Oper
From PS
auto on 11.2
AdminPowerMax AdminConsumption
(Watts) (Watts)
15.4
0 n/a
0 n/a
0 n/a
0 n/a
0 n/a
0 n/a
0 n/a
104.6
Power(Watts) Device
To Device
10.0 Ieee PD
10.0
Software Configuration Guide—Release 12.2(25)EW
n/a
n/a
n/a
n/a
n/a
n/a
n/a
Class
0
8-7