Using Software Commands; Using The Show Command - Cisco 7304 Installation And Configuration Manual

Chapter 6 Working with a CompactFlash Disk
Table 6-1 CompactFlash Disk-Related Software Commands (continued)
Command and Arguments
rmdir [disk0: | bootdisk:] directory-name
show [disk0: | bootdisk:]

Using Software Commands

This section provides examples of some of the basic software commands you can use with the
CompactFlash Disk. See
commands:
•
•
•
•
•
•
•
•
•

Using the show Command

To display information about CompactFlash Disk format and geometry, use the show [disk0: |bootdisk:]
command. The following example shows output from the show disk0: command:
System# show disk0:
******** ATA Flash Card Geometry/Format Info ********
ATA CARD GEOMETRY
ATA CARD FORMAT
Router#
OL-3967-01
Table 6-1
Using the show Command, page 6-3
Using the pwd Command, page 6-4
Using the cd Command, page 6-4
Using the dir Command, page 6-5
Using the format Command, page 6-5
Using the copy Command, page 6-6
Using the mkdir Command, page 6-7
Using the rmdir Command, page 6-8
Using the delete Command, page 6-8
Number of Heads:
Number of Cylinders
Sectors per Cylinder
Sector Size
Total Sectors
Number of FAT Sectors
Sectors Per Cluster
Number of Clusters
Number of Data Sectors 429536
Base Root Sector
Base FAT Sector
Base Data Sector
Description
Removes an existing directory.
Allows you to remove a directory that currently exists on a
CompactFlash Disk, where directory-name is the name of the
directory you want to remove.
Lists information about CompactFlash Disk format and geometry.
for optional arguments you can use with some of the following
16
840
32
512
430080
105
16
26822
338
128
370
Cisco 7304 Network Service Engine Installation and Configuration

Using Software Commands

6-3