Determining The Memory Configuration - Cisco 7304 Installation And Configuration Manual

Chapter 1 NSE-100 Overview
NSE-100 Memory Information

Determining the Memory Configuration

To determine the memory configuration of your NSE-100, use the show version command.
The following example shows an NSE-100 installed in a Cisco 7304 router:
Router# show version
Cisco Internetwork Operating System Software
IOS (tm) 7300 Software (C7300-JS-M), Version 12.2(14)S3, EARLY DEPLOYMENT RELEASE SOFTWARE
(fc1)
Copyright (c) 1986-2003 by cisco Systems, Inc.
Compiled Fri 01-Jul-03 18:17 by anonymous
Image text-base:0x40008970, data-base:0x4197C000
ROM:System Bootstrap, Version 12.1(20020207:195837) [biff-ha02 104],
RELEASED SOFTWARE
Currently running ROMMON from ROM 1
Router uptime is 0 minutes
System returned to ROM by power-on
System image file is "disk0:c7300-js-mz.NSE100CR_20020322"
cisco 7300 (NSE100) processor (revision 0x00) with 114688K/16384K bytes
of memory.
Processor board ID
R7000 CPU at 350Mhz, Implementation 39, Rev 4.0, 256KB L2, 1024KB L3 Cache
4 slot midplane, Version 65.48
Last reset from software reset or reload
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
PXF processor tmc0 running 'system:pxf/ucode1' v1.7 is active
PXF processor tmc1 running 'system:pxf/ucode1' v1.7 is active
1 FastEthernet/IEEE 802.3 interface(s)
4 Gigabit Ethernet/IEEE 802.3 interface(s)
1 Packet over SONET network interface(s)
509K bytes of non-volatile configuration memory.
31360K bytes of ATA compact flash in bootdisk (Sector size 512 bytes).
62720K bytes of ATA compact flash in disk0 (Sector size 512 bytes).
Configuration register is 0x0
Cisco 7304 Network Service Engine Installation and Configuration
1-9
OL-3967-01