Cisco 2611 - Router - EN User Manual page 92

Procedures for Recovering Boot and System Images
•
TR_SPEED_MODE—Sets the Token Ring speed and duplex mode. 0=4 Mbps
half-duplex mode, 1=4 Mbps full-duplex mode, 2=16 Mbps half-duplex mode, 3=16
Mbps full-duplex mode. The default is 2.
Note
network interface; or for routers with both an Ethernet and a Token Ring port, those
routers that are set to use the Token Ring port with the tftpdnld command.
•
TR_1E1R_PORT—Sets the port to be used with the tftpdnld command. 0=Use
Ethernet port, 1=Use Token Ring port. The default is 0.
Note
Ethernet and a Token Ring port.
After you specify the variables, you must reenter the tftpdnld command. For example:
rommon 1 > IP_ADDRESS=172.15.19.11
rommon 2 > IP_SUBNET_MASK=255.255.255.0
rommon 3 > DEFAULT_GATEWAY=172.16.19.1
rommon 4 > TFTP_SERVER=172.15.20.10
rommon 5 > TFTP_FILE=/tftpboot/c2600-i-mz
rommon 6 > tftpdnld
Invoke this command for disaster recovery only.
WARNING: all existing data in all partitions on flash will be lost!
Do you wish to continue? y/n: [n]:
Enter y to begin downloading the Cisco IOS software image. When the process is complete,
the ROM monitor mode prompt appears on your screen.
C-12 Cisco 2600 Series Hardware Installation Guide
Specify the TR_SPEED_MODE variable only for routers with a Token Ring
Specify the TR_1E1R_PORT variable only for those routers with both an
IP_ADDRESS=172.15.19.11
IP_SUBNET_MASK=255.255.255.0
DEFAULT_GATEWAY=172.16.19.1
TFTP_SERVER=172.15.20.10
TFTP_FILE=/tftpboot/2600-i-mz