Cisco 2611 - Router - EN User Manual page 88

Command Descriptions
In either case, the new virtual configuration register value is written into NVRAM, but
is not effective until you reset or power-cycle the router.
The following display shows an example of the confreg command:
rommon 7 > confreg
enabled are:
break/abort has effect
console baud: 9600
boot: the ROM Monitor
do you wish to change the configuration? y/n
enable
enable
enable
enable
disable "break/abort has effect"? y/n
enable
change console baud rate? y/n
enter rate: 0 = 9600,
change the boot characteristics? y/n
enter to boot:
0 = ROM Monitor
1 = the boot helper image
2-15 = boot system
enabled are:
diagnostic mode
break/abort has effect
console baud: 9600
boot: the ROM Monitor
do you wish to change the configuration? y/n
You must reset or power cycle for new config to take effect
C-8 Cisco 2600 Series Hardware Installation Guide
Configuration Summary
"diagnostic mode"? y/n
"use net in IP bcast address"? y/n
"load rom after netboot fails"? y/n
"use all zero broadcast"? y/n
"ignore system config info"? y/n
1 = 4800,
4 = 19200, 5 = 38400, 6 = 57600, 7 = 115200
[0]: 0
Configuration Summary
[n]:
[n]: y
[n]:
[n]:
[n]:
[n]:
[n]:
[n]: y
2 = 1200, 3 = 2400
[n]: y
[n]:
y
[0]: 0