Cisco 2611 - Router - EN User Manual page 91

The following tftpdnld command variables are optional:
•
TFTP_VERBOSE—Print setting. The default is 1.
— 0=quiet—After you enter the tftpdnld command, the prompt
Do you wish to continue? y/n:
is the only information that displays until the command completes successfully or
fails.
— 1=progress—Displays the state of the required tftpdnld command variables. Also
displays progress characters to indicate successful and lost packet transmissions.
— 2=verbose—Displays all progress print setting messages, along with error
information. The information provided by this print setting may be useful when
debugging interface link and configuration problems that may prevent connecting
to the TFTP server.
•
TFTP_RETRY_COUNT—Number of times from 1 to 65535 that the ROM monitor
will retry ARP and ACK. The default is 7.
•
TFTP_TIMEOUT—Overall timeout of the download operation in seconds. The range
is from 1 to 65535 seconds. The default is 7200 seconds.
•
TFTP_CHECKSUM—Performs a checksum test on the image. 0=checksum off,
1=checksum on. The default is 1.
•
FE_SPEED_MODE—Sets the Fast Ethernet speed and duplex mode. 0=10 Mbps
half-duplex mode, 1=10 Mbps full-duplex mode, 2=100 Mbps half-duplex mode,
3=100 Mbps full-duplex mode, 4=auto-negotiation. The default is 4.
Specify the FE_SPEED_MODE variable only for routers with a Fast Ethernet
Note
network interface.
Using the tftpdnld Command
Using the ROM Monitor C-11