Settings For The User - Alpha-InnoTec HT 6Split Installation And Operating Manual

15/18 Op mode
In this menu, you can select the operating mode for
the HT 6Split / HT 12Split unit. More information after
selecting " ? ".
Factory setting: auto
CAUTION
Recommended "auto" operating mode. Editing is only
16/18 Alarm actions
In this menu it is possible to activate alarm actions.
More information after selecting " ? ".
Factory setting:
decrease room temp: active
deactivate hot water: active
17/18 Reminder
of the user manual.
18/18 Start guide
In this menu, we can decide whether the start guide
will run again the next time the system is started.
40 Chapter 9 | Control

Settings for the user

Menu 1 - Indoor climate
the settings for the heating system. There are several
submenus in this. Status information for the relevant
menu can be found on the display to the right of the
menus.
Menu 1.1 - temperature
In this menu you can set the temperature for the heat-
ing system. Status information gives setpoints for the
heating system.
Choose between heating or cooling and then set the
desired temperature in the next menu "temperature
heating/ cooling" in menu 1.1. More information after
selecting " ? ".
Set the temperature (without room sensors installed
Factory setting: 0
HT 6Split
HT 12Split