Download Print this page
Assa Abloy Sargent EL980 Installation Instructions
Assa Abloy Sargent EL980 Installation Instructions

Assa Abloy Sargent EL980 Installation Instructions

Electric lockable non fire-rated mullion

Advertisement

Quick Links

Installation Instructions
EL980 Electric Lockable
Non Fire-Rated Mullion
Tools Required: Measuring Tape, Pencil, Drill & Tap Sizes #7 drill and 1/4"-20 tap, Concrete Drill 3/8" diameter, Center Punch,
Hammer, #3 Phillips Screwdriver, 5/64" Allen Wrench, 1/8" Allen Wrench
To install mullion in frame:
1. Close and block the doors against the frame stops. Check gap
betweendoor leaves and door to frame and correct if necessary.
2. Locate the center of the opening on the floor. Using the bottom
retainer, mark the positions for the two drop-in fasteners.
a. The bottom of the door should come to rest against the
surface of the mullion.
b. Modify threshold as required.
3. Drill holes with 3/8" diameter cement bit to a minimum depth
of 2-1/2".
4. Fasten bottom bracket to floor.
5. Locate the center of the opening on the top of the frame. Using
the top retainer, mark the positions for the four fasteners.
a. The door should evenly rest against both the frame stop
and the mullion.
b. If a top retainer mounting kit is used, modify weather
stripping as required.
6. Drill and tap each location for 1/4"-20 fasteners.
7. Mount top retainer on frame with fasteners provided.
8. Measure "Dim X" as shown. Remove material from the bottom
of the mullion per the formula: length of mullion = "Dim X" -
3/4".
Note: This leaves approximately 1/8" clearance between the
mullion and the top bracket when mounted.
9. Place mullion onto bottom bracket and pivot into opening to
latch.
10. Tighten bottom bracket set screw to prevent mullion rattle. Do
not over tighten (1/8" allen wrench).
11. Install exit devices according to manufacturer's instructions.
1-800-727-5477 • www.sargentlock.com
Copyright © 2005, 2008-2012, 2022, SARGENT Manufacturing Company. All rights reserved.
Reproduction in whole or in part without the express written permission of SARGENT Manufacturing
Company is prohibited.
Dim. "x"
WARNING
This product can expose you to lead
which is known to the state of California
to cause cancer and birth defects or other
reproductive harm. For more information go
to www.P65warnings.ca.gov.
Strain relief
Set screw for
stabilizing
the mullion
A7195E 9/22

Advertisement

loading
Need help?

Need help?

Do you have a question about the Sargent EL980 and is the answer not in the manual?

Questions and answers

Summary of Contents for Assa Abloy Sargent EL980

  • Page 1 Installation Instructions EL980 Electric Lockable Non Fire-Rated Mullion Tools Required: Measuring Tape, Pencil, Drill & Tap Sizes #7 drill and 1/4"-20 tap, Concrete Drill 3/8" diameter, Center Punch, Hammer, #3 Phillips Screwdriver, 5/64” Allen Wrench, 1/8” Allen Wrench Strain relief To install mullion in frame: 1.
  • Page 2 Assembly Instructions for EL980 Mullion Installation of cylinder: 1. Depress latchbolt and hold fully retracted. 2. Carefully thread cylinder with blocking ring into lock assembly until it bottoms out. ” 5/64 Allen Blocking Ring Wrench 3. Unscrew the cylinder orienting keyway at bottom. Cylinder 4.