Table of Contents
Advertisement
3.5 TCP/IP Settings
This page is used to configure the IP address parameters of the wireless access point for the local area
network, which connects to the Ethernet port of your wireless access point. Please make sure that the
IP address assigned to the wireless access point is available and is not being used by any other device
connected to the local area network.
IP Address
Subnet Mask
Default Gateway
DHCP
802.1d Spanning Tree
(STP)
Clone MAC Address
*Please click on the Apply Changes button or the Reset button at the bottom to save/reset the configu-
ration.
Items
The
192.168.10.100).
Subnet Mask of you LAN (default 255.255.255.0).
All devices on the network must have the same
subnet mask to communicate on the network.
Enter the IP Address of the AP in your network.
DHCP stands for Dynamic Host Configuration
Protocol. It is a protocol for assigning dynamic IP
addresses "automatically". In this device, manual
setting up your client IP is necessary when you
want to use the AP as your client's default gateway.
Enabled: Suitable for office environment, for exam-
ple, there are over 3 Ethernet switches or Routers or
APs are being used at the same time. Because STP
(Spanning Tree Protocol) needs 2~49 seconds to take
effect.
Disabled: Suitable for ordinary application when
there are less than 3 Ethernet switches or Routers or
APs working the same time, for example, ordinary
home.
Applies to Client mode only. Enter the MAC address
you would like to clone to the TPL-310AP. This will
be the MAC address that will appear on the access
point or wireless router you are connected to when
in Client mode. If there is no value here, then the
TPL-310AP MAC address will be used unless Enable
MAC Clone is check under Wireless > Basic Settings.
Section 3.4.2 (MAC Address Format: xxxxxxxxxxxx)
Information
IP
of
your
AP
LAN
port
(default
Advertisement
Table of Contents
