Setup And Operation - Refco TAP Installation And Operating Manual

English
Storage
- Storage temperature: -20 °C to +60 °C
- Humidity: 0 to 90% relative humidity (no condensation)

Setup and operation

TAP CLAMP
Set-up
TAP CLAMP compartment of the TAP CLAMP.
Switch on
Set
TAP CLAMP
ID
Set
Auto Off
Set unit
14
Instruction Manual TAP / Temperature And Pressure Gauge
Insert 3 x 1.5 V (AAA) batteries in the battery
Rem
Ensure the batteries are inserted observing the correct
polarities. Do not leave dead batteries in the battery
compartment. If you will not be using the TAP CLAMP
for a long period of time, remove the batteries from the
battery compartment.
- Press [ON/OFF] button, to switch on device.
After start image, display appears
- Press [ON/OFF] + [UNIT] button same time < 1 sec.
to enter set mode.
- Scroll from T1 to T6 by pressing [UNIT] button
< 1 sec.
- Press [ON/OFF] button ≥ 1 sec. to confirm and
return to main display.
Note:
Chosen ID will be transmitting to pressure gauge and is
shown on display.
- Press [ON/OFF] + [UNIT] button same time > 1 sec.
to enter set mode.
- When Auto Off mode is activated timer symbol
appears.
- Scroll from 10 / 20 / OFF by pressing [UNIT] button
< 1 sec.
- Press [ON/OFF] button ≥ 1 sec. to confirm and
return to main menu.
ropert
Note:
Factory default Auto Off is set to 20 min.
herm
Subsequent the symbol and the auto off time
empe
disappear from display.
ccurac
- Press [UNIT] button < 1sec.
- Switch between °C and °F by using [UNIT] button
< 1 sec.
Resolu
empe