Subscribe to Our Youtube Channel
Related Manuals for intensity IHWHS-04KC-3
Summary of Contents for intensity IHWHS-04KC-3
- Page 1 HIGH WALL CHILLED WATER 1 and 1.5 Tons. IHWHS-04KC-3, IHWHS-06KC-3 OWNER’S MANUAL MAN-O-IHWHS-0624 intensity.mx...
-
Page 2: Air Inlet
Air inlet Air outlet Inlet pipe Return pipe Drain pipe Infrared signal Temperature receiver display Operation lamp Timer indicator Display panel Bottom plate Faceplate Display panel Horizontal air deflector Remote controller... -
Page 3: Important Safety Information
1. IMPORTANT SAFETY INFORMATION To prevent water leak, contact your dealer. When the system is installed and runs in a small room, it is required to keep the concentration of the water, if by any To prevent injury to the user or other people and property chance coming out, below the limit. -
Page 4: Operation Range
Failure to observe could cause the chemicals to become Open the faceplate, and you can find the temporary button on deposited in the unit, which could endanger the health of the display panel. (Refer to Fig 2-1) those who are hypersensitive to chemicals. This function is used to operate the unit temporarily in case you misplace the remote controller or its batteries are exhausted. -
Page 5: Adjusting Air Flow Direction
Adjust vertical air Adjust the air flow louver properly and avoid direct air flow to Open the horizontal air deflector, and then manually adjust room inhabitants. vertical air deflector. Adjust the room temperature properly for a comfortable environment. Avoid excessive heating or cooling. faceplate Prevent direct sunlight during cooling operation by using curtains or blinds. -
Page 6: Maintenance Before A Long Stop Period
Maintenance before a long stop period (eg. at the beginning of the cold season) faceplate Drain the water system(for all heat exchangers). To avoid the risk of rupture due to freezing, it is advisable to drain the water from the system at the beginning of the cold season Maintenance before a long stop period (eg. -
Page 7: Troubleshooting
Symptom 3: White mist comes out of a unit Symptom 7: The outdoor unit fan does not spin. During operation. The speed of the fan is controlled in order to Symptom 3.1: Indoor unit optimize product operation. When humidity is high during cooling operation If the interior of Table 7-1 an indoor unit is extremely contaminated, the temperature distribution inside a room becomes uneven. - Page 8 Table 8-2 Symptoms Causes Solution Check whether the MODE When the automatic mode is indicated on the display is selected, the air conditioner will "AUTO" automatically change the fan The fan speed cannot be speed. changed. Protection against hot wind in Reduce the temperature of inlet in cooling mode.
- Page 9 MODEL: IHWHS-04KC-3 Information to identify the model(s) to which the information relation: Item Symbol Value Unit Cooling capacity(sensible) Prated,c 3.18 Cooling capacity(latent) Prated,c 0.63 Heating capacity Prated,h Total electric power input Pelec 0.034 Sound power level (per speed setting, if applicable)
- Page 10 Importado por: INTENSITY AIR, S. A. DE C. V. RFC: IAI-100609-SRA. Río Amacuzac #1125, Col. Valle Ote., CP. 66269 San Pedro Garza García, Nuevo León, México...
Need help?
Do you have a question about the IHWHS-04KC-3 and is the answer not in the manual?
Questions and answers