Subscribe to Our Youtube Channel
Related Manuals for USX-MOUNT WAS501
Summary of Contents for USX-MOUNT WAS501
- Page 1 WAS501 INSTRUCTION MANUAL If you have any questions along the way, just give us a call 1-800-460-0956 or mail to customerservice@x-mount.com. We’re ready to help! USA-C0...
- Page 2 CAUTION: PLEASE READ ENTIRE MANUAL PRIOR TO USE AND SAVE THESE INSTRUCTIONS Before getting started, let’s check below lists to make sure it is just right for you! CAUTION: DO NOT exceed the maximum weight Does your speaker indicated. This mounting system is intended for use only Max: (including accessories) No? Perfect –...
-
Page 3: Product Dimensions
Dimensions Product dimensions 41-310mm [1.61-12.20in] 60-120mm [2.37-4.73in] Ø35mm Ø [1.38in] Ø42mm Ø [1.65in] 824-1078mm [32.44-42.44in] 20mm [0.32in] [0.79in] 120mm [4.72in] 250mm 120mm [9.84in] [4.72in] 250mm [9.84in]... -
Page 4: Parts And Hardware
Parts and Hardware WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer; contact Customer Service. - Page 5 Hardware for Speaker Installation Screws Key Hole Bolt Nuts Washers M6X24mm M6X5mm M4x30mm M6x30mm Spacers Screws 1/4"-20UNC*12mm...
- Page 6 STEP 1 Choose rubber feet or carpet nails according to your floor type Option One: Rubber feet (pre-assembled on the product) for wooden, cement, tile or other hard floor. Adjust the rubber feet to level/adjust the base ( ) if the base is not level. Adjustable foot Option Two: If the stand is placed on carpet, remove the rubber feet first, install the carpet nail ( carpet...
- Page 7 STEP 2-1 Speaker Stand Assembly Insert Adjusting tube ( ) into bottom tube ( ) and use Allen key ( ) to fasten bolt (...
- Page 8 STEP 2-2 Speaker Stand Assembly Insert the Speaker attachment unit ( ) into the Adjusting tube ( ) and fasten it by bolt ( Wire...
- Page 9 STEP 3 Attach speaker to assembled stand (Option 1) For threaded mounting hole installation (the distance from mounting hole to the bottom of speaker should not exceed 310mm/12inch). According to your speaker's installation hole, choose screw ( ), spacer ( ) and M4 washer ( to attach it.
- Page 10 STEP 3 Attach speaker to assembled stand (Option 2) For keyhole installation: Pass the keyhole screw ( ) through the mounting hole of the speaker bracket ( ), and screw on the nut ( ) (no need to tighten). Hang speaker onto the keyhole bolt and then tighten the unt ( ).
- Page 11 STEP 4 Speaker with a wooden base and has no mounting holes at all Use wood screws (NOT provided in the package) to mount the speaker. Mark the installation holes' position on the bottom of the speaker and drill holes, then attach the speaker onto speaker stand.
-
Page 12: Step 5 Height Adjustment
STEP 5 Height adjustment By rotating the plastic nut, the height of the speaker stand can be adjusted from 32.4 inch to 42.4 inch. Tighten MAX:1078m[42.4in] MIN:824mm[32.4in] Loosen...
Need help?
Do you have a question about the WAS501 and is the answer not in the manual?
Questions and answers