Low-Battery Warning; Conserving Battery Power; Power Management Modes - Dell Latitude 131L User Manual

Check the Battery Health
To check the battery health using the charge gauge, press and hold the status button on the battery
charge gauge for at least 3 seconds. If no lights appear, the battery is in good condition, and more than
80 percent of its original charge capacity remains. Each light represents incremental degradation. If five
lights appear, less than 60 percent of the charge capacity remains, and you should consider replacing the
battery. See "Specifications" on page 135 for more information about the battery operating time.

Low-Battery Warning

NOTICE:
To avoid losing or corrupting data, save your work immediately after a low-battery warning, and then
connect the computer to an electrical outlet. If the battery runs completely out of power, hibernate mode begins
automatically.
By default, a pop-up window warns you when the battery charge is approximately 90 percent depleted.
You can change the settings for the battery alarms. See "Configuring Power Management Settings" on
page 44 for information about accessing the Power Options Properties window.

Conserving Battery Power

Perform the following actions to conserve battery power:
• Connect the computer to an electrical outlet when possible because battery life is largely determined
by the number of times the battery is used and recharged.
• Place the computer in standby mode or hibernate mode when you leave the computer unattended for
long periods of time. See "Power Management Modes" on page 43 for more information about standby
and hibernate modes.
• Select options to optimize your computer's power usage. These options can also be set to change when
you press the power button, close the display, or press <Fn><Esc>. See "Configuring Power
Management Settings" on page 44 for more information.
NOTE:
See "Battery Performance" on page 41 for more information on conserving battery power.

Power Management Modes

Standby Mode
Standby mode conserves power by turning off the display and the hard drive after a predetermined
period of inactivity (a time-out). When the computer exits standby mode, it returns to the same
operating state it was in before entering standby mode.
NOTICE:
If your computer loses AC and battery power while in standby mode, it may lose data.
To enter standby mode:
• Click the Start button, click Turn off computer, and then click Stand by.
or
43
Using a Battery