C&K systems SYSTEM 2316 Installation Manual page 12

SYSTEM 2316 Installation Manual
Command Locations 11 - 13: Receiver #2 Phone Number
Order in which the numbers will be dialed
Command Location 11
(1) (2)
Command Location 11: Receiver #2 Phone Number (digits 1 - 6)
Digit Positions (1) - (6):
0 - 9 = dialing digits
0 = dial tone detect
2 = * (DTMF dialing only, not used in pulse dialing)
3 = # (DTMF dialing only, not used in pulse dialing)
4 = end of number
5 = 5 second delay
Command Location 12: Receiver #2 Phone Number (digits 7 - 12)
Command Location 13: Receiver #2 Phone Number (digits 13 - 18)
Command Locations 14 - 16: RPS Phone Number
Command Location 14: RPS Phone Number (digits 1 - 6)
Command Locations 14 - 16 store the RPS Phone
Number used by the the COMMANDER II Remote
Programming Software. For additional information on
programming these Locations, refer to Receiver #2
above.
Command Location 15: RPS Phone Number (digits 7 - 12)
Command Location 16: RPS Phone Number (digits 13 - 18)
NOTE: In order to utilize the Remote Programming
feature, CL 0B, Digit Positions (3) and (4) must
also be programmed with YES.
(3) (4) (5) (6) (1)
Default Values
Default Values
Default Values
Default Values
Default Values
Default Values
Command Location 12
(2) (3) (4) (5) (6)
E
1 1
(1)
Digit (1) is dialed first.
You must place a
Fill in remaining positions with "0". The zeroes will not be
dialed.
0
1 2
(1)
0
1 3
(1)
E
1 4
(1)
0
1 5
(1)
0
1 6
(1)
12
Command Location 13
(1) (2) (3) (4) (5)
0 0 0 0
(2) (3) (4) (5)
4 (EON) after the last digit to be dialed.
0 0 0 0
(2) (3) (4) (5)
0 0 0 0
(2) (3) (4) (5)
0 0 0 0
(2) (3) (4) (5)
0 0 0 0
(2) (3) (4) (5)
0 0 0 0
(2) (3) (4) (5)
CL 11 - 16
(6)
0
#
(6)
0
#
(6)
0
#
(6)
0
#
(6)
0
#
(6)
0
#
(6)